Chasing CM600 User Instructions(lite version) contents 1. INTRODUCTION......................................................................................................................... 2 2. WARNINGS.................................................................................................................................. 2 3. CM600 PARTS............................................................................................................................. 3 4. How To Use CM600............
1. INTRODUCTION Thank you for purchasing and using the CHASING CM600, a robotic pool cleaner. It will provide you a convenient, reliable, and cost-effective cleaning experience. 2. WARNINGS 1) DO NOT enter the pool until CM600 is removed from the pool. 2) DISCONNECT the power supply when examining CM600. 3) Keep children away from CM600 when it works. 4) Ensure that the original power cable is used 5) Power cable only could be replaced by technicians certified by the manufacturer.
8) Keep the power supply at least 3M from pool’s edge, 0.1M above the ground while it is operating. 3.
3) Filtration 4. How To Use CM600 1) Position the power supply at a distance of 3M from pool’s edge, and 0.1M above the ground at least.
2) Unwind the cable and stretch it out completely so that it has no kinks. 3) Attach the cable to power supply, lined up with the groove in the socket, tighten the nut. 4) Place CM600 in the pool. 5) Plug in the power supply. 6) Click “MODE” button to select a cleaning mode, the corresponding light will be lit.
7) Click “START/STOP”button to stat CM600, it will work until a cleaning cycle finished. 8) The light of CM600(at the position shown in the figure) will be flashing while cleaning.
Normal operation Cycle on Error Red blinking 9) After a cleaning cycle, click “PULL UP”button, CM600 will reach the wall, and rise above the the water surface. You can also gently drag its cable to get CM600 come to the edge of the pool. 10) Grab the robot by the handle and pull it out the water. DO NOT pull it out the water by dragging the cable.
11) After cleaning cycle, open the filter cover, lift the basket, clean the filter basket. 5.
has no kinks. You can store CM600 in a protected area out of direct sun/rain/frost, at a temperature of between 5°-45°C. FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
ISED Statement English:This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).