User's Manual

ManualsBrandsCharles Machine Works ManualsElectronicsNarrow band UHF Transceiver

Radiometrix TR2I-464-5-12.5K RF Module Implementation Guide

Purpose: This guide is intended as guidance document to ensure that the radio module

identified is installed implemented in an appropriate manner so as to comply with the conditions

of the original FCC grant and IC certificate.

Applicability: RF module FCC ID.: ITQ-TR2I, IC:

3598A-TR2I

Use of External Antennas: The module was certified for use with the following antennas.

These antennas or antennas of the same design but lower gain may be used in the final

installation.

Antenna Type Gain

(dBi)

Manufacturer’s

P/N

Manufacturer

¼ Wave Whip 0 EXC450SM Laird Technologies

Final assembly antenna connection: The final assembly must have non-standard antenna

connection such as a reverse gender connector or means must be provided for permanent

connection of the antenna to the final assembly. A standard rf connector may not be used.

Final assembly labeling: The final assembly must contain a label notifying the user that the

device contains a certified rf module that is identified by the following product approval numbers:

FCC ID.: ITQ-TR2I

IC: 3598A-TR2I

An example of such a label is shown below.

Summary of content (4 pages)

PAGE 1
Radiometrix TR2I-464-5-12.5K RF Module Implementation Guide Purpose: This guide is intended as guidance document to ensure that the radio module identified is installed implemented in an appropriate manner so as to comply with the conditions of the original FCC grant and IC certificate. Applicability: RF module FCC ID.: ITQ-TR2I, IC: 3598A-TR2I Use of External Antennas: The module was certified for use with the following antennas.
PAGE 2
Human exposure to Radio Frequency (RF) energy: The module referenced in this document was evaluated to determine compliance with ANSI C.95 (USA) and Safety Code 6 (Canada). Unless specifically approved in a particular product use under this filing, this module can only be used in final assemblies that are used in a mobile environment where the radiating element is located a minimum of 20 cm. from the user or nearby persons.
PAGE 3
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:     Reorient or relocate the receiving antenna.
PAGE 4
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. “Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s).