User's Manual

Website: www.sunvote.com.cn Tech-Support Tel: [phone]-816 Mob: [phone] (24 hours)
Version: V1.0 Date: 2017-05-11 E-mail：[e-mail]
S52Plus Enterprise Quick User Manual
1. Keypad Management
Turn on: press any key to turn it on.
Turn off: Long press until LCD show to turn it off.
View keypad ID: press to view its ID when keypad is in standby mode.
See example.
View firmware version: Press to view current firmware version when
keypad is in standby mode. See example.
View matched channel number: Press to view current matched channel
number when keypad is in standby mode. See example.
2. Working Mode
New keypad should match to the specific base station before
use to avoid it being reused and added randomly.
 The matched keypads and base station can be identified
automatically when used as a whole set without
matching them again.
 Supports different working modes for different
applications. User can set different modes via “SunVote
ARS Tool Kit”.
Support 3 working modes: match mode, free mode and auto
mode.
 Match mode
How to use: Keypads connect to the base which is in match
mode automatically when turn on.
When to use: Multiple conferences in one place need to
avoid interference from each other and keypads can only
communicate with the matched base station, cannot
communicate with other base station in other conferences.
Steps for match mode:
Step 1: Open ARS Tool Kit and connect with the base
successfully.
Step 2: Go into “Keypad Match” interface and click “Start”.
Step 3: Press and on the keypad at the same
time for 3 seconds, keypad shows“-Channel-” and “OK”, to
indicate successful match.
 Free mode
How to use: When the base station connects to
computer
and in free mode, input the channel number of the
base station on keypad to connect to it.
When to use: For the user who votes at different
conferences. Keypad is able to communicate with any
base station freely by inputting the appropriate
channel of the base, and there is no interference.
Steps for free mode:
1. Long press until LCD shows “CH--“
2. Press alphanumeric keys to input the correct
channel number of the base on the keypads.
3. Press , LCD shows indicating successful
match.
 Auto mode
How to use: Keypads connect to any auto mode base
station directly after turn on.
When to use: Mostly for rentals. Rental Company
could distribute different sets to different places
quickly without too many configurations. Usually only
one conference in one place, as in auto mode,
adjacent different systems will have interference to
each other.
Submitted
LCD Display
Cancel
Down/Channel
Up/ Decimal Point
Submit
Signal strength
Alphanumeric keys
Data receiving
Low battery
Data transmitting
OK
OK