User's Manual

FAST OPERATION MANUL EA1000

EA1000 FAST OPERATION MANUL

INDICATE LED

· The Status LED indicates the communication status with PC, when flash quickly, it

stands that it received the data from PC.

· When the Data LED light, it stands receiving data from keypad

BASE STATION

CONNECTION

· Connect the base station with PC USB port , the Status LED will flash every half

second if connection is successful.

· The Status LED will flash quickly after the software and base station communicate

normally.

· Initial installation, PC will automatically remind that have found new device and

install the drive automatically.

RADIO

CHANNEL SET

· After logging in application software, choose the new channel in the “channel” of

“base station set”, then click “set”.

· When using the multiple base station solution, the frequency channel of each base

station should be different, and it’s better not to set the neighboring channel

· Only when frequency channel is interfered or communication is not good, then you

need to consider changing and resetting the channel, usually you needn’t.

BASE STATION

TEST

After connetion is ok, power on keypads, then do keypads testing.

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's

authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

Status LED

Data LED

USB Port

PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn

PAGE 1
FAST OPERATION MANUL EA1000 EA1000 FAST OPERATION MANUL Status LED USB Port Data LED INDICATE LED · The Status LED indicates the communication status with PC, when flash quickly, it stands that it received the data from PC. · When the Data LED light, it stands receiving data from keypad · Connect the base station with PC USB port , the Status LED will flash every half BASE STATION CONNECTION second if connection is successful.
PAGE 2
FAST OPERATION MANUL EA1000 guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.