User's Manual

EA1200 FAST OPERATION MANUL

INDICATE LED

· The Status LED indicates the communication status with PC, when flash quickly, it

stands that it received the data from PC.

· When the Data LED light, it stands receiving data from keypad

BASE STATION

CONNECTION

· Connect the base station with PC USB port , the Status LED will flash every half

second if connection is successful.

· The Status LED will flash quickly after the software and base station communicate

normally.

· Initial installation, PC will automatically remind that have found new device and

install the drive automatically.

RADIO

CHANNEL SET

· After logging in application software, choose the new channel in the “channel” of

“base station set”, then click “set”.

· When using the multiple base station solution, the frequency channel of each base

station should be different, and it’s better not to set the neighboring channel

· Only when frequency channel is interfered or communication is not good, then you

need to consider changing and resetting the channel, usually you needn’t.

BASE STATION

TEST

After connetion is ok, power on keypads, then do keypads testing.

Status LED

Data LED

USB Port

PAGE 1
EA1200 FAST OPERATION MANUL Status LED USB Port Data LED INDICATE LED · The Status LED indicates the communication status with PC, when flash quickly, it stands that it received the data from PC. · When the Data LED light, it stands receiving data from keypad · Connect the base station with PC USB port , the Status LED will flash every half BASE STATION CONNECTION second if connection is successful. · The Status LED will flash quickly after the software and base station communicate normally.
PAGE 2
FCC Caution. § 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.