Hardware Manual
BLE003moduleHardwareManual
FCCID:
2AMDBBLE003
IC:
22882‐BLE003
OverviewandKeyFeatures
The BLE003 module has been designed to allow OEMs to easily add Bluetooth wireless
connectivity in their product offering. The BLE003 module incorporates GEMHCI protocol
software specifically designed to enable fitness machines such as treadmills, exercise
bikes, ellipticals, rowers, stair climbers and step machines to wirelessly communicate
exercise data with smart phones, tablets, and leaderboard software systems.
The BLE003 module is based on Nordic Semiconductor’s nRF52832 multiprotocol
Bluetooth chipset. The BLE003 maximum transmits power of +4dBm. This manual is
intended to assist hardware integration of the BLE003 module into a given design.
Features
1-1. Product Name: Bluetooth Module
1-2. Bluetooth module: BLE003
1-3. Bluetooth specification: Bluetooth 4.2､Class2
1-4. MCU: Nordic nRF51822 SoC solution
1-5. Operation voltage: DC 1.7~3.3V
1-6. Communication type: GPIO, UART, SPI, I2C, PWM, ADC
FCC Warning:
“THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES AND INDUSTRY CANADA
LICENSE-EXEMPT RSS STANDARD(S). OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS
DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS
NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH
MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
(1) the module is limited to OEM installation ONLY
(2) the OEM integrator is responsible for ensuring that the end-user has no manual
instructions to remove or install module.
(3) the module is limited to installation in mobile or fixed application.
(4) the separate approval is required for all other operating configuration, including portable
configurations with respect to Part 2.1093 and different antenna configurations.
(5) Labeling instruction of finished product. Please refer to KDB 784748 D01
Industry Canada (IC) Warning:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le present appareil est conforme aux CNR dʼInnovation, Sciences et Developpement
économique Canada applicables aux appareils radio exempts de licence. Lʼexploitation est
autorisée aux deux conditions suivantes : (1) lʼappareil ne doit pas produire de brouillage,
et (2) lʼutilisateur de lʼappareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible dʼen compromettre le fonctionnement.