Hardware Manual

BLE002 module Hardware Manual
FCC ID: 2AMDBBLE002
IC: 22882-BLE002
Overview and Key Features
The BLE002 module has been designed to allow OEMs to easily add Bluetooth wireless
connectivity in their product offering. The BLE002 module incorporates GEMHCI protocol
software specifically designed to enable fitness machines such as treadmills, exercise bikes,
ellipticals, rowers, stair climbers and step machines to wirelessly communicate exercise
data with smart phones, tablets, and leaderboard software systems.
The BLE002 module is based on Nordic Semicondutor’s nRF52832 multiprotocol Bluetooth
chipset. The BLE002 maximum transmit power of +4dBm. This manual is intended to assist
hardware integration of the BLE002 module into a given design.
Features
1-1.Product name: Bluetooth module
1-2. Bluetooth module:BLE002
1-3. Bluetooth specification：Bluetooth 4.2､Class2
1-4. MCU: Nordic nRF51822 SoC solution
1-5. Operation voltage：DC1.7~3.3V
1-6. Communication type
：
GPIO,UART, SPI, I2C, PWM, ADC
FCC Warning:
“THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES AND INDUSTRY CANADA
LICENSE-EXEMPT RSS STANDARD(S). OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS
DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT
EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH
MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
FCC radiation exposure statement
This device complies with FCC radiation exposure limits for uncontrolled
environments.
(1) the module is limited to OEM installation ONLY
(2) the OEM integrator is responsible for ensuring that the end-user has no manual
instructions to remove or install module.
(3) the module is limited to installation in mobile or fixed application.
(4) the separate approval is required for all other operating configuration, including
portable configurations with respect to Part 2.1093 and different antenna configurations.
(5) Labeling instruction of finished product. Please refer to KDB 784748 D01
Industry Canada (IC) Warning:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR dʼInnovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence. Lʼexploitation est
autorisée aux deux conditions suivantes : (1) lʼappareil ne doit pas produire de brouillage,
et (2) lʼutilisateur de lʼappareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible dʼen compromettre le fonctionnement.