SG-2200 User’s manual
Contents 1. Administrators card registration 1.1. 2. Administrators card registration. User administration. 2.1.
User Manual SG-2200 1 Administrators card registration 1.1 Administrators card registration - Administrator card is used when a user registered in the SG-2200. - Registration procedure is shown in [Table 1] [Table 1] Administrators card registration procedure No. 1 Description Check if the green, blue and red LED emit light in sequence, after the terminal installed. 2 If confirmmed, tag the administrators RFID card in the box on the device.
User Manual 2 User administration 2.1 User Registration - Registration procedure [Table 2] [Table 2] User registration order No. Description 1 Tagging an administrator card is just a RFID card user registration status. 2 Make sure that the green LED is blinking. RFID card registration 1) When tagging your RFID card, the LED is turned to blue and back to 3 green blinking. 2) once more tagging to the administrator card for the final registration.
User Manual 3 Rule 3. 1. FCC Rule Federal Communications Commission (FCC) Statement Caution Changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. Warning This device complies with Part 15 of the FCC Rules.
