d SG-2100 User’s manual
d Contents 1. Administrators card registration 1.1. 2. Administrators card registration. User administration. 2.1.
d SG-2100 1 Administrators card registration 1.1 Administrators card registration - Administrator card is used when a user registered in the SG-2100. - Registration procedure [Table 1] [Table 1] Administrators card registration procedure No. 1 Description Check if the green, blue and red LED emit light in sequence, after the terminal installed. 2 If this check, the tagging device in the RFID card is included in the set. 3 If the blue LED flashes a success.
d 2 User administration 2.1 User Registration - Registration procedure [Table 2] [Table 2] User registration order No. 1 2 Description When tagging an administrator card, an RFID key card user registration status immediately. Please check that the green LED is blinking. Register your ID �If the ID is registered successfully, the LED is blinking momentarily changed to blue and back to green. 3 �When lead to problems with registration ID is shown in red, it LED blinking returns to green.
d 3 Rule 3. 1. FCC Rule Federal Communications Commission (FCC) Statement Caution Changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device.