사용자 매뉴얼d SG-2000 User’s manual
사용자 매뉴얼d Contents 隌붫»ǿ 隌붫»ǿ 2. 1. 1.1. Standby screen. 1.2. Certification Success / Failure screen. administrator Card Registration 2.1. 3. Screen description. administrator Card Registration. User Management. 3.1. User Registration 3.2.
User Manual SG-2000 1 Standby screen 1.
User Manual 1 Standby screen -
User Manual 1 Standby screen 1.
User Manual 2 Administrators card registration 2. 1 Administrators card registration -Administrator card is used when a user registered in the SG-2000 series. - Registration procedure [Table 2] [Table 2] Administrators card registration procedure 순 번 설 명 1 Check. After the terminal installed the green LED emits light when the user information is not present. 2 If this check, the tagging device in the RFID card is included in the set. 3 If the blue LED flashes a success.
User Manual 3. User administration 3. 1 User Registration - Registration procedure [Table 3-1] [Table 3-2] Each of the registration process ‣ If the ID is registered successfully, the LED is blinking momentarily changed to blue and back to green. ‣ When lead to problems with registration ID is shown in red, it LED blinking returns to green. [표 3-1] 사용자 등록 순서 순 설 번 명 1 When tagging an administrator card, an RFID key card user registration status immediately.
User Manual 3. 사용자 관리 [표 3-2] 사용자 등록 순서 5 Second fingerprint registration 6 Third fingerprint registration 7 RFID key card registration 8 W-Key registration 9 Confirmation page ※ Modify User, Delete and other terminal set is only available in network mode.
User Manual 3. User administration 3. 2 Delete user 순 설 번 명 1 When tagging an administrator card, an RFID key card user registration status immediately. 2 When tagging an administrator card once more in the state 1 is the clear mode. 3 Delete All Click Delete All button 4 Confirmation page Each of the registration process ‣ If the ID is registered successfully, the LED is blinking momentarily changed to blue and back to green.
Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device. 15.