User's Manual

Instruction Manual

Specification:

- Indoor and outdoor temperatures displayed on the main LCD readout

- Temperature measurement range:

Indoor main unit: 32F – 122F (0 ºC ~ +50 ºC)

Wireless remote unit: -4 F – 130F (-20 ºC ~ +55 ºC)

- Temperature resolution: 0.1 degree

- Transmission range : up to 100ft. in an open area

Instruction manual:

ATTENTION:

For the fist installation, insert the batteries in the display unit and then in the remote sensor

Battery installation:

Display unit

Insert 2 fresh “AAA” alkaline batteries into the display unit. (Batteries not included)

Remote sensor

Insert 2 fresh “AAA” alkaline batteries into the remote sensor. (Batteries not included)

Getting started:

Indoor Display unit

When the batteries are put into the display unit, it will display the indoor temperature .The outdoor

reading “----”

Remote sensor

When the batteries are placed into the remote sensor, it will signal the temperature to the display unit.

The display unit will then be able to display the outdoor temperature. You may need to push the Reset

button on the back of the display unit.

Reset button

PAGE 1
Instruction Manual Specification: - - Indoor and outdoor temperatures displayed on the main LCD readout Temperature measurement range: Indoor main unit: 32F – 122F (0 ºC ~ +50 ºC) Wireless remote unit: -4 F – 130F (-20 ºC ~ +55 ºC) Temperature resolution: 0.1 degree Transmission range : up to 100ft.
PAGE 2
Reset button Battery Icon Description: The battery icon will display The battery icon will display are low capacity. when the batteries are full. and the temperature readings will be blinking when the batteries When to replace the Batteries: For the remote sensor: When the battery icon of the outdoor window displays continuously the remote sensor batteries are low and need to be replaced.
PAGE 3
Troubleshooting: Using the Reset button on the Indoor unit (receiver): In some unusual occasions, the Indoor unit may be affected by electrical interference and respond abnormally. In such conditions, press the RESET button on the Indoor Display unit to resume normal operation. “RESETING” The Display unit should give you the indoor immediately and the outdoor temperature within 1 minute.
PAGE 4
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Trade Name: Model Number: 00782 Chaney Instrument Co. 965 S. Wells Street, Lake Geneva, WI 53147, Tel: 877-221-1252 LIMITED WARRANTY INTERNATIONAL Consumer may have more remedies at law than follows.