Chandler Limited REDD Microphone User Manual ® OFFICIAL EQUIPMENT For more information, visit www.chandlerlimited.com. © 2020 Chandler Limited, Inc. All Rights Reserved. REDD-MIC_UM_010820 Abbey Road Studios, EMI, REDD and their associated logos are trademarks of EMI (IP) Limited.
Thank you for purchasing the Chandler Limited REDD Microphone, you now own a piece of EMI / Abbey Road Studios official equipment. Continuing in the rich tradition of innovation at EMI, dating back to the early 1930s with Alan Blumlein, the father of ‘Stereo’, the company’s first coil microphones, velocity ‘ribbon’ mics and the “Blumlein pair” technique, Chandler Limited and Abbey Road Studios introduce the first new EMI badged microphone in over a half century, the ‘REDD Microphone’.
IMPORTANT QUICK START & POWER CYCLE PROCEEDURE 1. Mount the microphone to a suitable microphone stand using the supplied shock mount suspension apparatus. 2. PRIOR TO POWER-UP - CONNECTIONS a. Connect the microphone to power supply using the supplied 7-pin microphone cable. b. Connect the user supplied standard 3-pin XLR microphone cable to the audio interface or tape machine. c. Connect the power supply to an AC outlet. 3. POWER-UP a.
ON-BOARD MICROPHONE CONTROLS PRE AMPLIFIER The dedicated on-board REDD.47 Mic Amplifier (pre-amplifier) circuit provides the ability to use the REDD Microphone with or without the need for an external pre-amp. The preamplifier and most of its available features are adjustable directly from the microphone body.
POLE In cases where phase continuity relative to other microphones in the environment is required, an 180º polarity reversal of the output signal is achieved by use of the ‘POLE’ or phase reverse toggle switch available from the microphone body. When the toggle is set outward, to the circular or ‘O’ designation, phase is in its natural position at 0º. Conversely, when the switch is positioned to the left at the ‘ø’ designation, phase is reversed 180º.
The power supply (PSU,) supplied with the REDD Microphone kit is wired localized for regional AC, either 110V or 220V (115/230V, depending upon country of purchase. A REDD Microphone kit purchased in a region where AC is 110V (115V) standard cannot be used in 220V (230V,) unless it is modified for the correct operating voltage or an external power converter is used. NOTE: Some external power converters.
PSU FRONT PANEL T Y P E R E DD M I C R O P H ON E N TO U R CO -5 W - -6 The ‘OUTPUT’ control is operational regardless of the ‘PULL FOR LOW CONTOUR’ feature being actuated or not. -4 PULL FO RL -7 -3 -9 -I -2 -8 -I 0 0 PULL FO RL O O PUSH TIP- On drums room application, if a driven sound with tube saturation is the goal, turn up the gain, engage ‘DRIVE’ and turn down the ‘OUTPUT’ to not clip your converter’s input.
MAINTENANCE TECHNICAL SERVICE STORAGE U.S. SERVICE When the REDD Microphone is not in use for extended periods of time, please stow the microphone system in the supplied pressure controlled waterproof case, in a room temperature environment. Prior to sending in your gear for repair, please contact our shop at the number below. We will assist you in troubleshooting the problem and, if needed, we will issue you an RMA# to send in the gear.
REDD MICROHPONE SYSTEM Item Description Dimensions Weight Microphone Tube, Large Diaphragm Condenser 10.97(L)x2.46(W) in (278.64x62.48 mm) 1.11 lb / 0.504 kg Capsule Platinum membrane, custom handmade, handmilled x x Circuit REDD.47 Mic Amplifier, Tube x2 x x Gain Switchable / +4 to +33db in ‘NORM’ mode x x Maximum Gain Extended gain in DRIVE mode x x Patterns Cardioid / Omni x x PAD 10db / Switchable x x Phase 0-180º / Switchable x x 11.4(L)x4.04(W) x4.81(H) in (289.
Product Limited Warranty During the first year from the date of the original purchase, this product is warranted to be free from defects in materials and workmanship under normal use, service and maintenance. This warranty applies to the original purchaser and is subject to the following terms and conditions: What Is Covered: The product’s components as originally installed by the manufacturer that are defective in materials or workmanship under normal use, service and maintenance.
DISCLAIMER OF WARRANTY EXCEPT FOR THE FOREGOING WARRANTIES, CHANDLER LIMITED HEREBY DISCLAIMS AND EXCLUDES ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO ANY AND/OR ALL IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY WARRANTY WITH REGARD TO ANY CLAIM OF INFRINGEMENT THAT MAY BE PROVIDED IN SECTION 2-312(3) OF THE UNIFORM COMMERCIAL CODE AND/OR IN ANY OTHER COMPARABLE STATE STATUTE.