User's Manual

The Oracle Futura Remote has been designed exclusively for the Oracle Gate Access system. This
remote can access up to four different gate controllers.
Teaching an FRMT to the Gate Access Unit
Each Futura remote control has a unique internal ID, so that others cannot access
your Oracle Gate System.
The large button is considered Button #1, while the 3 smaller buttons are
considered #2, 3 & 4, respectively.
To begin using the remote, you must TEACH the remote to your system. Follow
the steps below:
Enter your master PIN number on the Oracle Gate Access Panel, followed by 8, then the gate
controller number (1-4). (If your system is controlling a single Gate Controller, enter 1).
The Gate Access unit will beep. Press the remote button you wish to control the gate with. The Gate
Access Unit will respond with a double-beep. That remote button now controls that Gate Controller.
Up to eight remotes can be used with the Oracle Gate System.
A triple-beep indicates that the remote was not successfully taught to the system. Repeat the above
steps.
Example: if your master PIN is 1234, and you wish button #1 to control the
gate: Enter 1 2 3 4 8 1 on the Gate Access Panel. After the Gate
Access panel beeps in response, press button #1 on the remote.
A double beep indicates success.
Teaching an FRMT to a Basic 315 or Ultrx315 Unit
Power down the Basic 315 or Ultrx315 and power it back up. Press the remote button you wish to use
to control the RX unit. The RX unit will buzz indicating teaching was successful.
Using the Futura Remote
To open a gate using the Remote, press the appropriate button on your remote for 3 seconds. You
should be less than 75 ft. from the Gate Access unit for reliable operation.
Battery The Futura remote operates on 2 CR1232 Lithium batteries.
Thank you for purchasing the Futura 315
Remote. This product has been designed
and manufactured in the USA, utilizing
the highest quality standards available.
FRMT
010207
Universal Wireless Solutions
Oracle(TM)
Futura Remote
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Changes or modifications not expressly
approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
International Electronics, Inc.
FCC ID: JLFFUT
Country Of Origin: USA
Warranty: This product is warranted to be free of defects for the period of One Year from the date of purchase. The warranty covers parts, labor, and
return shipping to you, but not all accessories. IEI will repair or replace any defective product at our discretion. Warranty does not cover misuse or
damage other than due to normal operating conditions. If you need to send the system to IEI for repair, contact IEI for a Return Authorization number via
email: [e-mail]. Packages without a Return Authorization number will be rejected.