User's Manual

ManualsBrandsChamberlain Wireless Products ManualsElectronicsWireless Motion Alert

Table Of Contents

Overview

The Wireless Motion Alert uses a Passive Infra-Red

(PIR) sensor to detect movement of people and

vehicles, while allowing small animals to pass through

undetected. The base station can be powered by 4

AA batteries for hours of continuous, wire-free

operation or plugged in using the AC adapter.

Model CWA2000

Wireless Motion Alert

Base Station

Passive Infra-Red (PIR)

Motion Sensor

Swivel Bushing

Mounting Plate

AC Adapter

Rubber Pads

Sun/Rain Shield

Operation & Features

Batteries: The AA batteries (not provided) in the

base station should last up to one month. If the base

station batteries are low, it will beep every few

minutes. The AA batteries (not included) in the PIR

motion sensor will last up to 2 years depending on

use (lithium batteries are recommended for colder

environments). For peak performance, inspect

batteries annually and replace as needed.

Programming Additional PIR Motion Sensors: The

Base Station can learn the code of up to 3 additional

PIR Motion Sensors, responding with unique buzzes.

To program additional PIR Motion Sensors see

Step 6.

To order additional PIR Motion Sensors call

1-800-528-9131.

Clear Memory: Press and hold the Learn Button on

the Base Station until 3 beeps are heard.

On/Off: To turn the base station on and off, hold

down the power button until you hear the on/off tone.

Volume: The base station is equipped with

adjustable volume controls. The lowest volume

setting is the mute feature.

To prevent possible SERIOUS INJURY or DEATH from

electrocution, outputs are suitable ONLY for controlling low

voltage devices, 24V max, ac or dc.

Carton Inventory

Antenna

On/Off Button

Volume

Base Station

Summary of content (4 pages)

PAGE 1
® Model CWA2000 Wireless Motion Alert Overview The Wireless Motion Alert uses a Passive Infra-Red (PIR) sensor to detect movement of people and vehicles, while allowing small animals to pass through undetected. The base station can be powered by 4 AA batteries for hours of continuous, wire-free operation or plugged in using the AC adapter. To prevent possible SERIOUS INJURY or DEATH from electrocution, outputs are suitable ONLY for controlling low voltage devices, 24V max, ac or dc.
PAGE 2
PIR Motion Sensor Assembly & Test Step 1 Step 3 Attach PIR Motion Sensor box to mounting plate with large silver screw. Tighten screw until PIR Motion Sensor stays in place when repositioned. Insert battery pack facing away from circuit board and attach cover. NOTE: Ensure the batteries do not touch the circuit board and the antenna and battery wires are not pinched. Step 2 Step 4 Install 4 AA Alkaline batteries (not provided). (Lithium batteries recommended for colder environments.
PAGE 3
Programming PIR Motion Sensor to Base Station PIR Motion Sensor Installation Step 7 Step 5 AC Adapter Input Mount PIR Motion Sensor horizontally on solid surface a few feet off the ground and within 1/2 mile of Base Station (rotate sensor to access screw holes). Unit should be able to swivel as needed. Attach sun/rain shield. NOTE: Keep PIR Motion Sensor antenna away from metal objects. Do not mount PIR Motion Sensor in direct sunlight, near moving tree branches, or in the path of a sprinkler system.
PAGE 4
Troubleshooting The PIR Motion Sensor lights up, but the Base Station does not respond. The PIR Motion Sensor must be programmed to Base Station (See Step 6). Ensure Base Station is on and is not muted. If the green power light is not lit or is flashing, press the Mute Button on the top of the Base Station to wake it up. If the green power is illuminated, look at the two small white Base Station switches next to the Learn Button. The #1 Dip Switch should be down, towards the circuit board.