CGOLDENWALL Projector Lift User Manual *CONTACT US* Amazon seller: CGOLDENWALL Service email : sunflowersmile20130401@hotmail.
Product Description CGOLDENWALL motorized projector lift (hereinafter referred to as the "lift") adopts a double-scissor structure and a dual-belt lifting principle. It has the characteristics of elegant appearance design, safety and reliability, accurate positioning, low noise and convenient installation. It is widely used in projection, lighting and audio projects.
Specifications FT100 FT150 FT200 Size of lift Fold up (mm) 350X300X410(L1) 350X300X460(L1) 350X300X510(L1) Size of lift Extended (mm) 350X300X1250(L) 350X300X1750(L) 350X300X2150(L) 410 460 510 Bottom Plate size(mm) 480x480 480x480 480x480 Loading Capacity 10Kg(Max) 10Kg(Max) 10Kg(Max) Rated voltage 100-120V/220-240V 100-120V/220-240V Max Power consumption 38W 76W 76W Tilt angle ±22.5° ±22.5° ±22.
Installation Installation requirements 1.The lift shall work indoor where there is no any corrosive or combustible substance; and should not approach the steam pipe, hot air pipe, or other central heating equipment. 2.Voltage: 100-120V or 220-240V, Power: 38-76W Installation 1.
. Limit position adjustment method (important steps must be adjusted): There are two limit switches on the side the top. On the left is the upper limit setting button, and on the right is the lower limit setting button. The upper limit is the position where the ascent stops, and the lower limit is where the descent stops. The steps to set the upper limit are as follows: 1. Use the remote control to control the lift to the desired position and press the stop button. 2.
Ceiling Installation plate Explosion screw Lower Limit Switch Upper Limit Switch Please make sure the 4 screws get through the holes to correct position, then lock the security screw tightly to prevent the lower part of the lift from sliding.
OPERATION Remote Controller Up Stop Down Adjustment of upper and lower limit Upper limit: Move leftwards to enlarge the running distance; move rightwards to shorten the running distance. Lower limit: Move leftwards to shorten the running distance; move rightwards to enlarge the running distance.
Trouble shootings Problems Parts received damaged. Solutions Please contact us and we will replace new part for you free of charge. The lift can only go down but cannot go 1. Please check if the power plug is loose; up. 2. If there is no problem with the power supply, the lower limit should be set too long and it needs to be reset. The remote control fails. Please don't keep pressing the remote control button, otherwise it will activate its thermal protection function.