E103-DCX_Digital cordless phone user manual
1 Parts list:......................................................................................................................................3 2 Feature ...........................................................................................................................................3 3 Operation Guide (with commercial power) ...................................................................................3 3.1 Volume control...................................................................
1 Parts list: Each box contains the following component: A. (2) Line cords: 1-RJ45 and 1-RJ11 B. Battery for handset C. Base unit D. Mobile handset E. Paper faceplate F. Protective plastic faceplate overlay G. Power adapter The following are optional Items possibly included: (must be ordered separately) H. Handset package:charging station, power adapter, battery and handset 2 Feature A. Phone circuit can directly drive hands-free B. Digital wireless and no interference technology C.
is the volume decrease; there are 5-step volume levels; when tuned to the maximum or minimum sound level would have a warning beep. 3.2 pickup and hang-up Base unit:on-hook status, press line or speaker key to pick up with speaker; again,after the talking, press line or speaker key again to hung-up. Handset:Press “ON/OFF” key in the handset faceplate to pickup or hung-up. 3.
3.7.2 Register handset Manual register: press down “Page” key for 3 seconds, the line indicator begin quickly flashing, the base unit enter into the register mode, and then press “*” key in the handset until the phone give an “toot” prompt tone, release the “*” key, the handset enter into the register mode, when the base and the handset matches successfully, and then the phone will give a beep prompt sound. Every base unit most can register 5 handsets.
4 Program key 4.1 Flash The base unit is pick up, press “store” key, hear of “toot” sound, the message indicator begins flashing at the same time, and the phone enter into configuration mode, after pressing any numeric key (0 represents flash time is 1000ms, 1 represents 100ms… 9 represents 900ms), press “store” key again, press “flash” key at last; after the flash time set successfully, the phone will give a long “toot” prompt sound. The flash time set range is 100-1000ms. 4.
l Never install telephone or Ethernet jacks in wet locations unless the jack is specially designed for wet locations. l Never touch uninstalled telephone wires or terminals unless the telephone line has been disconnected at the network interface. l Use caution when installing or modifying telephone and network lines. l Be sure your power adaptor meets your regions requirements prior to installation. 6.1 Connect power line cord Two line cords are provided 1-RJ45 & 1-RJ11.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
service may be required. But if advance notice isn't practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. 4. The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment.
This product meets the applicable Industry Canada technical specifications. / Le présent matériel est conforme aux specifications techniques applicables d’Industrie Canada. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.