Getting Started Guide

6 7

Installation Installation

Two rubber bushing sizes are provided. The thinner bushings are

for RZR vehicles with 1.75 inch ROPS tubing. The thicker bushings

are for ACE and ATV vehicles with 1.5 inch tubing.

First Method - Mounting via Pipe Clamp (Bracket)

• Tighten bolt down to securely hold bracket in place.

• Do this for both Pipe Clamps as two are included with each speaker bar. NO less that two should be used during

installation.

• Place top Pipe Clamp over the bar the unit will be mounted to. Make sure you have chosen the correct rubber bushing

for your tube size. Put the rubber bushings above the mounting pipe and below (as shown below)

Note: Placing the included rubber bushings between the Pipe clamps, above and below, will reduce the possibilty of

scratching your UTV bar during installation.

• Place the ﬂange end bolt through the bracket strap and base. Tighten down with the included mounting bolts until the

bar is securely locked in place.

• Connect wires to power, ground, and ignition.

The RPMSB3X/RPMSB4X can be used with any 12-volt system and can be mounted to a variety of bars using the

included hardware. The unit has three wires in its wiring pigtail. The red wire, 12V + (or B+), should be directly

connected to the vehicles positive battery terminal, the black wire, ground 12V - (or B-), should be connected directly

to the vehicle’s chassis where paint has been removed or the negative terminal on the battery, and the blue wire,

accessory, should be connected to the ignition wire on the vehicle thru the included “Carling” style rocker switch.

The unit includes two low clearance brackets that ﬁt 1.75" and 2" bars. The clamps can be used ONLY on the top

channel and can be adjusted to ﬁt multiple types of bars including vertical, horizontal, or angled bars allowing for

multiple installation options.

Mounting

1. Via Pipe Clamp (Bracket)

2. Via Straight Bolt through Dove Tail “Slide” piece

First Method - Mounting via Pipe Clamp (Bracket)

• Take 14 mm bolt with lock washer and place it through bottom of clamp and slightly thread into Dove tailed

“Slide” piece. You will need a 5mm Allen to accoomplish this task.

• Slide assembly and lock washer into the recessed “notched” area placing the unit at angle/mounting

location to dial in bracket angle and placement.

OVERVIEW OF SOUNDBAR AND THE 2 METHODS OF INSTALLATION

Pipe Clamps

Rubber Bushings

Straight Bolt

“Slide”

Rubber Bushings (UPPER)

PIPE BRACKET MOUNT

Rubber Bushings (LOWER)

5mm Allen Wrench

Pipe Clamp

Pipe Clamp(Upper)

Pipe Clamp(Lower)

Rubber Bushings

5mm Allen Wrench