XED SERIES SOUNDBARS 3761 S. Hill St.
Thank you for purchasing a Cerwin Vega Mobile SoundBar for your audio system. You have chosen Cerwin Vega Mobile because you deserve the best! Cerwin Vega Mobile SoundBars are designed and engineered to the highest quality standards in the industry to create the ultimate listening experience in your vehicle. For optimal performance of this product, it is highly recommended that you have your new SoundBars installed by an authorized Cerwin Vega Mobile dealer.
stem Wiring/Connecting PRODUCT SPECIFICATIONS RPMSB3X RPMSB4X 1. If installing on an electric vehicle,switch it into TOW mode. Carefully remove the Positive (+) then Negative (-) battery wires. Max Power 400 W MAX 800 W MAX RMS Power (4 Ω) 100 W 200 W RMS 2. If installing on a gas vehicle,wire the Negative (Black) wire to the Negative (-) battery terminal and the Positive (Red) wire to the Positive (+) battery terminal.
Installation Set up/Operation Features/Functions 7 1 1. Tap the Power button to turn the unit on. (Power, Ground, and ACC wire need to be connected to a 12V power source.) 2. Tap the Power button to switch modes between Bluetooth and AUX. 3. Hold the Power button for 2 seconds to turn the unit Off. Note: The buttons will stay illuminatedas long as the ACC wire has 12V applied to it. 4. The included fuse loop, ring terminals, and butt connector allow for easy wire connection to a 12V power source.
Installation Installation OVERVIEW OF SOUNDBAR AND THE 2 METHODS OF INSTALLATION The RPMSB3X/RPMSB4X can be used with any 12-volt system and can be mounted to a variety of bars using the included hardware. The unit has three wires in its wiring pigtail.
Solid Tube Install (Golf Cart) Physical Dimensions Second Method - Mounting via Threaded Bolts (this would be for Golf Cart typically) RPMSB4X 1. Included are two threaded bolts that fit into the “Slide” . 24.7” / 627mm 2. Slide the dove tail aluminum part with bolts into the recessed “notched” area. 3. Spread bolts with slide into the desired location where the unit is to be tightened down. 4. Measure the dimension between the bolts. Use this as the hole line up 5.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
