Instructions

ManualsBrandsCerno ManualsCeiling LightsMica L 1-Light LED Unique / Statement Geometric Pendant

Pendant xture

Installation Instructions

CERNOGROUP.COM T_949.715.1534

2139 1/2 LAGUNA CANYON RD. LAGUNA BEACH CA 92651

General Product information

This product is suitable for indoor dry locations only.

This product can be dimmed with an electronic low voltage

(ELV) dimmer. Please see “Dimmer Compatibility” section of

these instructions for more information.

Adjusting the Fixture Height

Measure the desired height (H )that

you want the xture to hang below the

ceiling.

Thread the cable through the shade,

canopy fastener, canopy, crossbar, and

washer. (See Figure 2)

Tie a knot in the cable at the desired

length H

CAUTION - RISK OF FIRE

This product requires installation by a qualied

electrician. Before installing be sure to read

all instructions and TURN POWER OFF TO THE

JUNCTION BOX

Black (-)

Red (+)

Black (HOT)

White (NEUTRAL)

Black (-)

White (+)

Grey Wire Nuts

White (NEUTRAL)

Black (HOT)

8-32 Screw

Knot

Washer

Crossbar

Canopy

Typical 3” Plaster Ring

110V AC Electrical Service

Canopy Fastener

Shade

LED Light Engine

Yellow Wire Nuts

LED Driver

Figure 1

Figure 2

Junction Box

Summary of content (2 pages)

PAGE 1
Pendant fixture Installation Instructions General Product information Adjusting the Fixture Height This product is suitable for indoor dry locations only. This product can be dimmed with an electronic low voltage (ELV) dimmer. Please see “Dimmer Compatibility” section of these instructions for more information. 1 Measure the desired height (H )that you want the fixture to hang below the ceiling. 2 Thread the cable through the shade, canopy fastener, canopy, crossbar, and washer.
PAGE 2
Pendant fixture Installation Instructions Mounting the Fixture 4 Attach the crossbar to the junction box using the supplied 8-32 screws. Making Electrical Connections 5 Make electrical connections as shown in figure 2 using the supplied wire nuts. 4 WARNING - THE LED DRIVER IS A DC DEVICE AND MUST BE ATTACHED TO THE LED LIGHT ENGINE AS SHOWN. CONNECTING THIS DEVICE INCORRECTLY WILL CAUSE SEVERE DAMAGE.