User's Manual

3-Series

Micro Motion Sensor

QUICK START GUIDE

3328

Device Overview

Getting Started

Step 1: Open ZigBee Network for Joining

Using your controller or hub’s interface, enable the

ZigBee network for joining.

Step 2: Pull Tab from Bottom of Sensor

Pull the small plastic tab out from the side of the

sensor and it will immediately begin searching for a

network to join.

Step 3 (Optional): Finish Joining at Hub

Some hubs and controllers require additional steps

such as naming or categorizing the device.

LED Light Patterns

Pattern Description

Blue | Blinking Establishing Connect / Joining

Green | Short Joining Successful

Red | Blinking then

White | Solid

Power Outage /

Emergency Lighting

Red | 3 Blink Series Low Battery

PIR Sensor

CR-2450 Battery

Reset Button

Status LED

PIR SensorPIR SensorPIR Sensor

PAGE 1
3-Series Micro Motion Sensor QUICK START GUIDE 3328 Device Overview PIR Sensor Reset Button Status LED CR-2450 Battery Getting Started LED Light Patterns Step 1: Open ZigBee Network for Joining Pattern Description Using your controller or hub’s interface, enable the ZigBee network for joining.
PAGE 2
Troubleshooting Specifications Remove and Replace Battery from Device Slide out the tray to reveal battery. Remove battery and replace with a new CR-2450 battery. Reassemble and test operation. Power: Rated: 3V Battery: CR-2450(1x) Battery Life: Up to 2 years Factory Reset and Rejoin Slide out battery tray. Then press the reset button by inserting a pin or paperclip in the reset button hole. While holding down the reset button, slide the battery tray back into the device to factory reset.