User's Manual

IMPORTANT!
READ THESE INSTRUCTIONS BE-
FORE INSTALLING DIMMER
Wireless Dimmer and
Remote Keypad
Installation Guide
WARNING!
If a direct short is created
between the RED wire and
GROUND or NEUTRAL, the Dimmer
will be damaged and unusable.
Dimmer and Keypad
Installation
24 Hour Technical Support
CentraLite Systems, Inc.
6420 Wall Street
Mobile, AL 36695
(877) 466– 5483
SupportedModels
3‐ButtonDimmer
 3385003(‐A‐I‐LA‐W)
1‐ButtonDimmer
 3385001(‐A‐I‐LA‐W)
RemoteKeypad3‐Button
3385003‐K(A,I,LA,W)
RemoteKeypad1‐Button
 3385001‐K(A,I,LA,W)


SpecificationsandSupportedLoads
Thisdimmerisdesignedtoworkasanindependent
deviceoraspartofaJetStreamDeviceNetwork.It
mountsinastandardwallboxandfollowsconven‐
tionalwiringstandards.Thedevicecanbecontrolledby
otherdevicesintheJetStreamDeviceNetwork.
Power:120/240VAC50/60Hz
SupportedLoads
•
120VAC800WIncandescent
• 120VAC800WHalogen
• 120VAC800WFluorescent
• 120VAC800VAMagneticLowVoltageTransformer
• 120VAC800VAElectronicLowVoltageTransformer
Ifdimmerisinstalledinamulti‐gangwallboxthedevice
eachdevicemustbede‐ratedto600W.
OperatingTemperature
Allloadratingsarelistedinaccordancetoanambienttem‐
peratureof25degreesCelsius.
Communications
2.4GHz,16channelspreadspectrumradiofrequency
Warning!Toreducetheriskofserious
injuryordeath,turnpowerOFFbeforeinstall‐
ingthisproduct.
Warning!Thisdevicemustbeinstalledby
competentlicensedelectricians.
Caution!Usingthisproductin
anymannerotherthanoutlinedin
thisdocumentvoidsyourwarranty.
CentraLiteisnotresponsibleforany
damageincurredasaresultofmis‐
useorabuseofthisproduct.For
moredetailsseethe“Li mited5Year
Warranty”

1. Confirmthattheintendedinstallationlocationcon‐
formstothefollowingrequirements:
• Wallboxmustmeetboxsizerequire‐
mentsspecifiedbytheNEC(National
ElectricCode)
• Installationwillbecompletedaccording
tonationalandlocalcodes.
• Theloadbeingcontrolledbythedevice
doesnotexceed800W.(600Winmulti‐
ganginstallation.
2.ToavoidSERIOUSINJURYorDEATH,turnOFF
thelocalelectricalpowerfeedingtheswitchloca‐
tion.Todisconnectpowerturnoffthebreakeror
removethefusefromthefusebox.
Verifythatthere
isnopowerpresentusingavoltagemeterortest
light.

3. Ifyouareretrofittinganexistingswitchusingthe
JetStreamdimmerorkeypadremovetheexisting
switch.NotewhichwiresaretheGround,Circuit
Feed(HOT),Load(SwitchLeg),andNeutral.
4. Preparethewires
forconnectionusingprovided
wirenuts.Stripofftheinsulation5/8ofaninch.
5. ConnecttheJetStreamDimmerorKeypadWires
usingthesuppliedwirenuts.
• ConnectGREENwiretoGROUND
• ConnectBLACKwiretoHOTFEED
• ConnectWHITEwiretoNEUTRAL
• ConnectREDwiretoLOAD
6. Testallconnections.Foldwiresandpushthem
neatlyintotheswitchbox.Alignthedimmerinthe
switchboxwiththeairgapswitchorientedatthe
bottomofthedimmer.Usingthesuppliedscrews
securethedimmerorkeypadintheswitchbox.
7. VerifythattheAir
Gapswitchisfullypushedin.
ThenturnONcircuitbreakerorreplacethefuse.
8. Ifthedimmerisinstalledproperlythetopledwill
blinkslowlysignifyingthatthedeviceisworkingas
aindependentlocalnon‐dimmingdevice.Ifthe
deviceisnotblinkingrefertothe
Troubleshooting
section.
9. Youshouldnowbeabletocontroltheloadbytap‐
pingthetopbutton.
Warning! This product must be
grounded in accordance to NEC and
Local requirements.
Dimmer
ConnectionDiagram
Ifyouhavequestionsabouttheinstallationof
theJetStreamsystempleasecallCentraLitetech‐
nicalsupporttollfreeat:


1‐877‐466‐5483
Orvisittheonlinehelpdeskat:
www.centralite.com/helpdesk
Three‐WaywithLoadat
EndofCircuit