User's Manual

EUT: Frequency Hopping Device Report No: 0048-050207-01
Model: CA100 FCC ID:ST2-CA100
Advanced Compliance Laboratory, Inc. 6 Randolph Way, Hillsborough, NJ 08844, tel:[phone]
User Manual
The CA100 module can be interfaced with the user’s Board through the 20 pin connector
designated as GB052A- 20S- H22- TSD- B. This is a standard commercial connector.
Remote Play, Inc. software is the only software authorized to operate the module. The software
must be integrated by Remote Play, Inc.
In order to allow proper operation of the module, the antennas are permanently attached to the
module and their shape needs to adhere to the shape below. The antennas must have “guides” to
make sure that the antennas comply with the authorized shape as is shown below:
The module connector pins are shown in the schematics and should be only used with Remote
Play, Inc. Software version RPI-CA100-10. The Vcc voltage must be 3 volts +/- 10% and all the
digital signals comply with standard CMOS “1” and “0” requirements. The maximum RSSI
signal is 1.6 volts.
The maximum data rate that Remote Play, Inc. uses in this module is 16 kbps.
The minimum hopping frequency is 907 Mhz.
The maximum hopping frequency is 923 Mhz
The maximum peak power is less than 7 dBm using any bandwidth.
The minimum sensitivity is –103 dBm.
Typical communication range is > 500 feet
Installation Instructions
1. The module is ESD sensitive and should be handled accordingly. Make sure that a
ground strip is used at all time.
2. Before connecting the module make sure that the connection pins adhere to the specs:
a. Pins 1,3, 5,6, 16, 17, 18 19 and 20 are properly grounded.
CA-100 Module
Top View
TX
Antenna