User's Manual

ManualsBrandsCentrak ManualsElectronicsDIM Hygiene Monitor IT-370/373/374/375

Table Of Contents

Document Name:

HWM Installation Guide

Document Version Number:

201010CT203022MAN

Effective Date:

10/01/10

Confidential & Proprietary. DO NOT Copy or Distribute.

Page 1 of 6

CenTrak

Hand Washing Monitor

Hardware Installation

Guide

Warning:

This guide is in draft form and can be changed without notice at

anytime by CenTrak. Please contact CenTrak prior to commercial

use to receive all the necessary and latest information about the

system.

Caution: Any changes or modifications not

expressly approved by the party responsible

for product compliance could void the user's

authority to operate the equipment.

Summary of content (6 pages)

PAGE 1
CenTrak Hand Washing Monitor Hardware Installation Guide Warning: This guide is in draft form and can be changed without notice at anytime by CenTrak. Please contact CenTrak prior to commercial use to receive all the necessary and latest information about the system. Copyright © 2010 CenTrak, Inc. All rights reserved. Caution: Any changes or modifications not expressly approved by the party responsible for product compliance could void the user's authority to operate the equipment.
PAGE 2
How to Install the CenTrak Hand Washing Monitor Hardware Items Needed ............................................................... 3 Small Round Soap Dispenser Installation ................ 4 Large Round Soap Dispenser Installation ............... 5 Flat Front Sanitizer Dispenser Installation ............... 6 Small Round Dispenser Large Round Dispenser Document Name: Document Version Number: Effective Date: Confidential & Proprietary. DO NOT Copy or Distribute.
PAGE 3
CENTRAK HWM HARDWARE INSTALLATION GUIDE How to Install the CenTrak Hand Washing Monitor Hardware Items needed for Installation Round back mounts to dispenser  CenTrak Hand Washing Monitor  Rounded back, double stick adhesive mount (for use on round dispensers)  Flat double stick adhesive mount (for use on flat front dispensers) Flat side mounts to HWM For use on flat front type dispensers Document Name: Document Version Number: Effective Date: Confidential & Proprietary.
PAGE 4
CENTRAK HWM HARDWARE INSTALLATION GUIDE Small Round Soap Dispenser A-1. Peel off flat side of adhesive backing and firmly place flat side down onto Hand Washing Monitor as shown in Figure A-1. Round back mounts to dispenser Flat side mounts to HWM Press on firmly for 15 seconds. Fig. A-1 A-2. Peel off curved side of adhesive covering and place Hand Washing Monitor (HWM) onto dispenser, making sure to mount more than 3 inches above push mechanism (where soap comes out).
PAGE 5
CENTRAK HWM HARDWARE INSTALLATION GUIDE Large Round Soap Dispenser B-1. Peel off flat side of adhesive backing and firmly place flat side down onto Hand Washing Monitor as shown in Figure B-1. Round back mounts to dispenser Press on firmly for 15 seconds. Flat side mounts to HWM Fig. B-1 B-2. Peel off curved side of adhesive covering and place Hand Washing Monitor onto dispenser, making sure to mount above push mechanism (3” above where soap comes out). Press firmly and hold for 15 seconds. Fig.
PAGE 6
CENTRAK HWM HARDWARE INSTALLATION GUIDE Flat Front Sanitizer Dispenser C-1. Using the flat double stick mounting adhesive, Peel off adhesive backing and firmly place onto back of Hand Washing Monitor. Then remove backing from other side. Fig. C-1 C-2. Place HWM onto dispenser, 4-5 inches above where soap comes out. Press firmly and hold for 15 seconds. Fig. C-2 Document Name: Document Version Number: Effective Date: Confidential & Proprietary. DO NOT Copy or Distribute.