GLM-100 802.
FCC Statement Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. GLM-100 Wireless mini Module complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
or transmitter This device is intended only for OEM integrators under the following conditions: The antenna must be installed such that 20 cm is maintained between the antenna and users. For laptop installations, the antenna must be installed to ensure that the proper spacing is maintained in the event the users places the device in their lap during use (i.e.
Service Center in U.S.A Company Name : D-Link Corporation.
1. Introduction The GLM-100 Wireless module This module is the wireless networking device based on 802.11g technology and compatible for interoperability with existing 802.11b devices. This device provides 54Mbps transfer rate in wireless network. GLM-100 is designed for Printer Server series, IP Camera series and Internet Video Server gives you wireless access the web and network resource without the wire.
3. Specification Wireless Specifications Standard IEEE 802.11g, IEEE802.11b ,Wi-Fi compliant Chipset Ralink RT2560 Interface PCI interface Connector One I-PEX connector LED N/A Frequency Range 2.412GHz-2.4835GHz n 2.412-2.462 GHz(North America) n 2.412-2.484 GHz(Japan) n 2.412-2.472 GHz(Europe ETSI) n 2.457-2.462 GHz(Spain) n 2.457-2.472 GHz(France) Number of Selectable n USA, Canada: 11 channels Channels n Europe: 13 channels n Japan : 14 channels n 802.
4.1. Installation Overview GLM-100 wireless module is design for IP Camera series and Internet Video Server only.
4.2. Safety Recommendations The safety guidelines are as follows: λ Keep the board area clear and dust-free before, during, and after installation. λ Keep tools away from walk areas where you and others could fall over them. λ Do not wear loose clothing or jewelry, such as earrings, bracelets, or chains, that could get caught in the board. λ Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
4.4. λ Installing a GLM-100 Remove the GLM-100 module from its protective packaging. λ Avoiding Electrostatic Discharge Before you install the GLM-100 module, ground yourself by touching a piece of metal to avoid electrostatic discharge (ESD). You should also take the following precautions to prevent damage to the GLM-100 module: λ Keep the GLM-100 module in its antistatic-shielded bag until you λ are ready to install it. Handle the GLM-100 module by its edges.