2C L
PRECAUTIONS On the Road Using a phone while driving is illegal in many countries. Please refrain from using your mobile while driving. Near Sensitive Electronics or Medical Equipment Don’t use your phone near sensitive electronic equipment – particularly medical devices such as pacemakers – as it could cause them to malfunction. It can also interfere with the operation of fire detectors and other automatic-control equipment. While Flying Your phone can cause interference with aircraft equipment.
1. UNDERSTANDING YOUR PHONE 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Speaker 5MP front camera Sensor Volume up Volume down Power key Touch button/Calling Touch button/Unlock phone Touch button/Camera Flash/Flashlight 8MP camera 3.
2. REMOVING BACK COVER/BATTERY INSTALLATION 1. Lift and remove rear case as shown below on the bottom left corner of the phone. 2. Insert the battery matching up the gold terminals on the top left of the battery and clip in place. 3. Reinstall the back cover and click in place. SD card MICRO NANO WCDMA850/900/1700/1900 GSM850/900/1800/1900 EARN2 CL CAPHG58 IMEI 1: 000000000000000 IMEI 2: 000000000000000 SN: CellAllure000001 MARCA: CellAllure 3.8V GENTLY LIFT AND UNCLIP THE BACK COVER HERE 3.
Inserting/Removing SD Card • The SD card slot is located next to the SIM card slots near the battery terminals as indicated on the phone itself. • Gently insert the SD card noting the correct direction as indicated on the phone and push until the SD card clicks in place. • To remove simply pull gently. Power ON/OFF ON Press the POWER button for a continuous 5 seconds until the phone turns “ON.” OFF Press the POWER button for a continuous 5 seconds. A selection menu will appear. Select “OFF” to power “OFF.
5. TOUCH BUTTONS The button displays a menu of recently opened applications. The button returns immediately to the main screen. The button moves back one step to the previous menu/page. Screen Lock To lock the phone’s screen, simply press the “POWER BUTTON.” Screen Unlock When the phone is in idle mode, press the “POWER BUTTON” once to wake up the phone. Screen unlock: To unlock, swipe up as illustrated below: 6. HOME SCREEN The home screen will look similar to the picture opposite.
The status bar displays system information, such as current time, wireless connectivity and battery charge status. From the home screen, slide your finger from the top of the screen down to the center to access the notification panel as illustrated below. 9:00 4G 4G 09:00 2019/01/01 Drag the notification menu down to display the second fast access menu. Through this menu it is possible to modify the functions such as brightness, auto rotation, Wi-Fi, Bluetooth and more as displayed below. 4G 4G 9:00 7.
• Wi-Fi – Connect to/disconnect from wireless networks, view connection status. • Data usage – Enable/disable mobile data, view current usage, set mobile data limit. (note: this function is available only on devices supplied with 3G card functionality) • Bluetooth – Connect or disconnect Bluetooth devices. • Display – Adjust display settings. • Smart Gesture Settings – “ON” / “OFF.” • Audio Profiles – Adjust the various audio settings such as ringtones.
9. ANSWERING AND REJECTING CALLS To answer a call – Slide your finger to the Green Call answer key. To reject a Call – Slide your finger to the Red Call End key. To message – touch the message icon. 10. SENDING A MESSAGE On the home screen, Messaging 4G 4G , enter message edit interface. 9:00 4G 4G 9:00 For Text Message 1. Input recipient number on the Type name or number. While you input the number, matching contacts will appear under the bar for you to select.
. FOR MULTIMEDIA MESSAGE 1. Input recipient number on the Type name or number bar. 2. Click Menu > Add Subject, then type the Subject. 3. Click Compose to start composing a message. 4. Click add Attach. Note: • You can select Capture picture, Pictures, Capture videos, Videos, Record audio, Audio, Contact, Calendar, Slideshow from the attachment list. 5. After you finish typing, click Send. 12. SOFTWARE KEYBOARD Touchscreen The touchscreen responds to finger touch.
13. HOW TO CONNECT TO A COMPUTER Note: • Turn on your phone before connecting it to a PC by USB cable. 1. Use a USB cable to connect the phone with a computer. The phone will automatically detect a USB connection. 2. A notification will pop up “USB connected” – Select the desired functionality. 3. The PC will detect an external disc named “EARN2 CL” this is the internal memory of the phone. 4. The USB connection has been successful. 14. CONNECTION TO INTERNET Wireless: 1. Select “ Settings” 2.
Web Browsing Connect to the Internet and launch the browser. 4G 4G 9:00 16. BLUETOOTH Select “Bluetooth” and, to turn ON slide to ON. Then to turn OFF slide to OFF. Search for the device you would like to pair with and select “PAIR.” You will see a message “Connected Successfully.” 17.
1. Touch the icon 2. Touch the icon to take a photo. to start camera recording. 3. Touch the icon on the top right to see the previous picture and to delete, share or set it as wallpaper. Click return button to exit camera interface. 4. Touch the icon to switch from front to back camera. 18.TROUBLE SHOOTING Close Application When an application is not responding you can manually shut the app down in “Running Services” menu. This will ensure the system responds as desired.
19.
WARNING: Factory Data Reset setting will delete ALL your data and system configuration as well as any downloaded apps. Please use this function carefully. SPECIFICATIONS CPU/PCB solution: MTK 6739 Display: 5.
16
PRECAUCIONES En el camino Utilizar un teléfono mientras conduce es ilegal en muchos países. Por favor absténgase de utilizar su teléfono móvil mientras conduce. Equipos electrónicos o equipo médico cercano. No utilice su teléfono cerca de equipos electrónicos – dispositivos médicos como marcapasos especialmente, ya que podría causar un mal funcionamiento del mismo. También pueden interferir con el funcionamiento de los detectores de fuego y otros equipos de control automático.
1. CONOCE EL TELÉFONO 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Auricular Cámara Frontal de 5MP Sensores Subir Volumen Bajar Volumen Tecla de encendido Botón táctil/ Llamando Botón táctil / Desbloquear teléfono Botón táctil /Cámara Flash / Linterna Cámara de 8MP Entrada para el auricular 3.
2. REMOVER LA CUBIERTA TRASERA/INSTALACIÓN DE LA BATERÍA 1.Levante y retire la tapa trasera como se muestra abajo en la esquina inferior izquierda del teléfono. 2.Inserte la batería emparejando los terminales dorados en la parte superior izquierda de la batería y presionando hasta que quede en su lugar. 3.Vuelva a instalar la tapa trasera y haga clic para que quede en su lugar.
Insertar o quitar la tarjeta del Micro SD • La ranura para la tarjeta Micro SD se encuentra al lado de las ranuras de las tarjetas SIM cerca de los terminales de la batería como se indica en el propio teléfono. • Inserte suavemente la tarjeta Micro SD señalando la dirección correcta como se indica en el teléfono y presione hasta que la tarjeta del Micro SD quede en su lugar. • Para quitar simplemente tire suavemente la tarjeta.
5. BOTONES TÁCTILES El Botón muestra un menú de aplicaciones recientemente abiertas. El Botón retorna inmediatamente a la pantalla principal. El Botón retrocede un paso hacia la página de menú anterior. Bloqueo de pantalla Para bloquear la pantalla del teléfono, simplemente pulse la tecla “ENCENDIDO.” Pantalla de desbloqueo Cuando el teléfono está en modo inactivo, presione el botón “ENCENDIDO” una vez para activar el teléfono.
La barra de estado muestra información del sistema, tal como hora, conectividad inalámbrica y estado de carga de batería. Desde la pantalla principal, deslice su dedo desde la parte superior de la pantalla hasta el centro para acceder al panel de notificación tal como se ilustra a continuación. 4G 4G 9:00 09:00 2019/01/01 Arrastre el menú de notificación hacia abajo para mostrar el segundo menú de acceso rápido.
• Uso de datos: Activar o desactivar los datos móviles, uso actual, establecer el límite de uso de datos móviles (Nota: esta función sólo está disponible en dispositivos de funcionalidad 3G). • Bluetooth: Conectar o desconectar los dispositivos Bluetooth. • Pantalla: Configuración de la pantalla. • Configuración para Smart Gesture: Activar o desactivar la función. • Perfiles de audio: Ajustar las diferentes configuraciones de audio como tonos de llamada.
9. RESPONDER Y RECHAZAR LLAMADAS Para contestar una llamada, deslice el dedo a la tecla de respuesta de color verde. Para rechazar una llamada, deslice el dedo a la tecla fin de llamada de color rojo. Para mensajes, toque el icono de mensaje. 10. ENVIAR UN MENSAJE En la pantalla de inicio, Mensajería un mensaje. 4G 4G 9:00 , se introducirá a la interfaz de editar 4G 4G 9:00 Para mensajes de texto 1.
11. MENSAJES MULTIMEDIA 1. Ingrese el número o nombre de receptor en la barra de destinatario, mientras inserta el número, contactos que coincidan con los datos, aparecerán debajo de la barra para seleccionar. 2. Haga clic en Menú > Agregar tema, a continuación, escriba el asunto. 3. Haga clic en redactar para comenzar a componer un mensaje. 4. Haga clic para agregar adjuntar para agregar archivos adjuntos.
13. CÓMO CONECTARSE A UNA COMPUTADORA Nota: Encienda el teléfono antes de conectarlo a una computadora a través de cable USB. 1. Utilice un cable USB para conectar el teléfono con un ordenador. El teléfono detecta automáticamente una conexión USB. 2. Una notificación aparecerá “USB conectado” – seleccione la funcionalidad deseada. 3. El PC te detecta un disco externo llamado "EARN2 CL" está es la memoria interna del teléfono. 4. La conexión de USB ha sido exitosa. 14. CONEXIÓN A INTERNET Wireless: 1.
Navegación por la web Conectarse a Internet y poner en marcha el navegador. 4G 4G 9:00 16. BLUETOOTH Seleccione “Configuración” --- Seleccione Bluetooth a “ENCENDIDO.” Buscar el dispositivo que desea conectar y seleccione "EMPAREJAR.” Usted verá un mensaje “Conectado correctamente.” 17.
1. Toca el icono de para tomar una foto. 2. Toca el icono de para iniciar la grabación de la cámara. 3. Toca el icono de en la parte superior derecha para ver la imagen anterior y borrar, compartir o definirlas como papel tapiz. Haga clic en volver para salir de cámara interfaz . 4. Toca el icono de para cambiar entre cámara frontal y cámara trasera. 18.
19.
ALERTA: Restablecer Datos de Fábrica borrará toda la información en el sistema al igual que configuraciones y Aplicaciones descargadas. Por favor use esta función cuidadosamente. ESPECIFICACIONES CPU: MTK 6739 Pantalla: 5.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: ( 1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 15.21 Information to the user. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 15.105 Information for the user.
2C L