Instructions / Assembly

Parts Included:
x6 Glass Panels
To Ensure Quality Assembly:
Lay out parts on flat surface, grouped
together by type of part
Make sure plastic safety backing
remains in place on all screws to
prevent cracking or shattering the glass
Step 1: Begin working from the bottom
up by connecting two upside down
glass panels using a linear connector
with foot. Make sure the “Caution-Hot”
sign is on at least one of the panels,
and facing out.
Step 2: Work your way around the
panels. Keep the screws loose to assure
that the connectors are positioned
correctly, and tighten only once all of the
connectors and glass paneslare proper-
ly in place. The glass corners should be
resting to either side of the rubber foot.
Step 3: Make sure that all of the
connectors are tightened as much as
possible and are properly pressing onto
the glass. Slowly and carefully, flip the
flame guard over to the other side, with
the connectors with feet now touching
the ground. Repeat step 2.
Step 4: 4. Once you have added the
linear connectors on the other side, go
around to all of the connectors and
make sure that the screws are holding
the glass panels tightly in place.
x4 Linear Connectors
x4 Corner Connectors
with Foot
Tools Needed:
Phillips Head Screwdriver