Installation Instructions

TECHNICAL NOTE
MC001
26/03/2020
1/3
Sensing your future
WWW.CELEC.FR
The information and notices contained in the document
are not binding and do not imply contract proposals.
They may be modified by CELEC without prior notice. All rights reserved.
3 boulevard de l’Europe
76270 NEUFCHATEL-EN-BRAY · FRANCE
Tel. : [phone]
Blue Connect Module
Take control of your sanitary ware with CELEC’s smart Blue Connect module. Connected sanitary ware offers improved
hygiene and experience in washrooms whilst optimising maintenance and management of your efciency.
Installation data, alerts and remote commands are available via smartphone for point to point access and PC
for network wide access to all installations.
The module can be controlled by the Blue Connect App which works on both Android and iOS, on smartphones
as well as tablets. It can also communicate with a Gateway to connect to a local area network (LAN) or wide
area network (WAN).
Characteristics
• Monitor data to
- Identify installation problems and anomalies
- Anticipate maintenance interventions
- Optimise cleaning schedules depending on afuence
- Record the water consumption of your sanitary
ware installations
• Shut-off installations remotely for cleaning or
maintenance purposes
• Log data to
- Verify respect of hygiene procedures
- Track anti-legionella and bacteria rinse cycles
• Optional ow rate and temperature sensors
- Monitor actual water consumption for leak
detection and solenoid valve maintenance
- Monitor actual water temperature for anti-
scalding protection and legionella control
• Alerts for battery replacement and maintenance
• Wireless low energy communication protocol for
operation with batteries
• Download statistics
Advantages
Applications
Kitchen
faucet
WC
Urinal
ShowerBathroom
faucet
Soap
dispenser
Operating voltage 4-12VDC
Average consumption ≈ 100 μA
Communication
frequency
2.4GHz
Status LED
Green / Red
Connectors
Waterproof IP67 (adapters
available on request)
Software update Over the air
Material compatibility
Celec sensor, solenoid valve,
temperature probe, ow meter as
well as CELEC approved pumps
and motors. Check with CELEC
for compatibility with non-CELEC
components.
Operating temperature 0° to +50°C
Storage temperature -20° to +70°C
Europe Certication
RED 2014/53/EU directive compliance
USA Certication
THE GRANTEE IS NOT
RESPONSIBLE FOR
ANY CHANGES OR
MODIFICATIONS NOT
EXPRESSLY APPROVED BY
THE PARTY RESPONSIBLE
FOR COMPLIANCE.
SUCH MODIFICATIONS
COULD VOID THE USER’S
AUTHORITY TO OPERATE
THE EQUIPMENT.
FCC ID: 2AVPG-MCX
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any
interference received, including
interference that may cause
undesired operation.
Also, some specic recommendations
for exposure to magnetic elds must
be followed: this equipement complies
with FCC’s radiation exposure limits
set forth an uncontrolled environment
under the following conditions:
1- This equipment should be installed
and operated such that a minimum
separation distance of 20cm is
maintained between the radiato
(antenna) and user’s nearby person’s
body at all times.
2 - This transmitter must be co-located
or operating in conjunction with any
other antenna or transmitter.
Memory capacity 4Mb
Temperature probe type NTC
Power source Batteries or power supply
Protection IPx5