User's Manual

ManualsBrandsCCT Tech Advanced Products ManualsElectronics900MHz Analog Modulation Cordless Phone

900MHz Cordless Phone

Operating Instructions

Model No. KX-TC1466LAB

KX-TC1466LCB

KX-TC1467LAB

Pulse-or-tone dialing capability

PLEASE READ BEFORE USE

AND SAVE.

PQQX13565ZA F1102-0 D

1 Getting Started

2 Making/Answering Calls

3 Speed Dialer

4 Special Features

5 Things You Should Know

6 Quick Guide

Contents by Section

Charge the battery for 15 hours

before initial use.

For your future reference

Serial No. Date of purchase

(found on the bottom of the unit)

Name and address of dealer

KX-TC1466LAB

Panasonic Communications Co., Ltd.

1-62, 4-chome, Minoshima, Hakata-ku, Fukuoka 812-8531, Japan

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS

PRODUCT TO RAIN OR ANY TYPE OF MOISTURE.

If there is any trouble, disconnect the unit from the telephone line and

connect a known working phone. If the known working phone operates

properly, do not reconnect the unit to the telephone line until the trouble

has been repaired. If the known working phone does not operate

properly, consult your telephone company.

Summary of content (15 pages)

PAGE 1
900MHz Cordless Phone Operating Instructions Model No. KX-TC1466LAB KX-TC1466LCB KX-TC1467LAB Pulse-or-tone dialing capability PLEASE READ BEFORE USE AND SAVE. Charge the battery for 15 hours before initial use. Contents by Section KX-TC1466LAB 1 2 3 4 5 6 Getting Started Making/Answering Calls Speed Dialer Special Features Things You Should Know Quick Guide WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN OR ANY TYPE OF MOISTURE.
PAGE 2
1 Getting Started 1-A Accessories Section 1 1-B Location of Controls ∑ AC Adaptor . . . . . . . . . . . . . . . . one Handset Base unit Antenna (1-C, 5-B) Antenna IN USE/CHARGE Indicator (1-C, 4-E) Hook (5-C) ∑ Telephone Line Cord . . . . . . . . . one ∑ Battery . . . . . . . . . . . . . . . . . . . . one (PAUSE/REDIAL) (2-A, 4-D) RINGER Selector (2-B) Charge Contacts (5-A) 900MHz SS CORDLE (OFF) (1-C, 2-A) (–––/FLASH) (2-A, 4-A) ∑ Handset Cover . . . . . . . . . . . . . .
PAGE 3
2 Making/Answering Calls 2-A Making Calls (PAUSE/REDIAL) IN USE Indicator RINGER Selector To adjust the receiver volume 2 3 Dial a phone number. 4 levels (HIGH, MEDIUM, NORMAL, LOW) are available. Press (LOUD) while talking. To hang up, press (OFF) or place the handset on the base unit. ≥The indicator light goes out. ≥Each time you press (LOUD), the volume level will change. If noise interferes with the conversation Press (CH) to select a clearer channel or move closer to the base unit.
PAGE 4
Special Features “ Special 4-A For Call Waiting Service Users Press (–––/FLASH) if you hear a call-waiting tone while talking. ≥The first call is put on hold and you can answer the second call. ≥To return to the first caller, press (–––/FLASH) again. ≥The call waiting service cannot be used when a parallel connected telephone is in use. ≥If this function does not operate properly, consult your telephone company for details.
PAGE 5
Special Features Section 4 4-D How to Use the PAUSE Button (For PBX Line/Long Distance Calls) We recommend you press (PAUSE/REDIAL) if a pause is required to dial with a PBX or to make a long distance call. Ex: Line access number (9) (PBX) (9) ¤ (PAUSE/REDIAL) ¤ Phone number ≥Pressing (PAUSE/REDIAL) once creates a 3 second pause. This prevents misdialing when you redial or dial a stored number. ≥Pressing (PAUSE/REDIAL) more than once increases the length of the pause between numbers.
PAGE 6
5 Things You Should Know “ 5-C Wall Mounting 5 This unit can be mounted on a wall. 1 2 Push the lower side of the hook (1) and pull down the hook until it locks (2), so the tab holds the handset. ≥Make sure to place the handset with the keypad facing down. ≥The IN USE/CHARGE indicator lights and a beep sounds.
PAGE 7
Things You Should Know Section 5 5-F Before Requesting Help Problem The unit does not work. An alarm tone sounds. Cause and Remedy Problem Cause and Remedy ≥Check the settings (1-C). ≥Charge the battery fully (5-A). ≥Clean the charge contacts and charge again (5-A). ≥Install the battery properly (1-C, 5-D). ≥Place the handset on the base unit and unplug the AC adaptor to reset. Plug in, and try again. You cannot store a phone number in memory.
PAGE 8
6 Quick Guide Section 6 6-A Preparation 1 2 Connect as shown. Fasten the AC adaptor cord to prevent it from being disconnected. Hook For maximum distance and noise-free operation, place the base unit in a HIGH and CENTRAL location with no obstructions or interference from electrical appliances. Raise the antenna. Install the battery in the handset and close the handset cover, locking it into place. Black Lead 3 Red Lead Charge the battery for about 15 hours.
PAGE 9
PQQX ZA-5 02.6.18 2:45 PM ページ 34 Important Safety Instructions When using this unit, basic safety precautions should always be followed to reduce the risk of fire, electric shock, or personal injury. 11. Read and understand all instructions. 12. Follow all warnings and instructions marked on this unit. 13. Unplug this unit from AC outlets before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning. 14.
PAGE 10
PQQX ZA-5 02.6.18 2:45 PM ページ 35 CAUTION: To reduce the risk of fire or injury to persons, read and follow these instructions. 1. Use only the battery(ies) specified. 2. Do not dispose of the battery(ies) in a fire. They may explode. Check with local waste management codes for special disposal instructions. 3. Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed. 4.
PAGE 11
PQQX ZA-5 02.6.18 2:45 PM ページ 36 FCC and Other Information This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US:AAA-----. If requested, this number must be provided to the telephone company. Registration No. . . . . . . . . . . . . . . . . . . . . . . . . . (found on the bottom of the unit) Ringer Equivalence No. (REN) . . . . . . . . . . . . .
PAGE 12
PQQX ZA-5 02.6.25 10:04 AM ページ 37 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this phone.
PAGE 13
PANASONIC CONSUMER ELECTRONICS COMPANY, DIVISION OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA One Panasonic Way Secaucus, New Jersey 07094 PANASONIC SALES COMPANY, DIVISION OF MATSUSHITA ELECTRIC OF PUERTO RICO, INC., Ave. 65 de Infanteria, Km. 9.
PAGE 14
PQQX ZA-5 02.6.18 2:46 PM ページ 39 For product service ≥Call 1-800-211-PANA(7262) or 1-800-833-9626 for the location of an authorized servicenter. ≥Panasonic’s e-mail address for customer inquiries: consumerproducts@panasonic.com for customers in the USA or Puerto Rico ONLY When you ship the product ≥Carefully pack your unit, preferably in the original carton. ≥Attach a letter, detailing the symptom, to the outside of the carton.
PAGE 15
PQQX ZA-5 02.6.18 2:46 PM ページ 40 If you need assistance with the set-up or operation, please call 1-800-211-PANA(7262) Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way, Secaucus, New Jersey 07094 Panasonic Sales Company, Division of Matsushita Electric of Puerto Rico, Inc. Ave. 65 de Infantería, Km. 9.