FH29638 EQUIPMENT APPROVAL INFORMATION Your option: acquisition is approves! for connection ta the Pal Switched Telethons Network an in carbuncular wih pars 15 and 88. FC Rules and Regulations il ie Technical Requirements fo Elephants Terminal Equipment puts oy ACTS.
10. Ali ow the phone to charge for 12 hours prior to first use. If you don't properly charge the phone, battery performance will be compromised. 11. Set the RINGER program on the cordless handset to ON, if this icon displays on screen. (Please see the details on chapter of Ringer Setting) Note: The phone automatically defaults to touch-tone dialing. “To change to pulse {rotary} dialing, see “Tone/Pulse Dialing”. if you don't know which type of service you have, check with the pane company.
. Press LINE Cohen or SPEAKERPHONE i" button again to hang up or put the corded handset on cradle 10 hang up. REDIAL ~ 1. Press REDIAL “W" button, a CC» icon displays on screen, 2. Press the “A” or button to review redial telephone fist. (6 previous up fo 20 digits dialed numbers that you can select) 3. Press LINE button on cordless handset, or SPEAKERPHONE " button on base, or pick up the corded handset to dial out the number. DELETING THE CURRENT REDIAL RECORD 1. Make sure the phone is OFF. 2.
1. Press INT/EXIT button on handset 2. Enter the handset number {ali handset and base)} that you want to transfer to. Handset will page specific handset, at the same time an intercom melody will be heard for 30s until the handset answer the paging. {if user haven't enter the number, then all handsets will ring} *If user no expansion handset had been registered, user don't need to press handset number for selection. 3.
4. Press the PROGRAMMER button. 5. Press number key {01-16} to store the phone number in the memory location. VIP MEMORY You can specify a desired memory to VIP, if the memory had been specify to VIP, you will hear a VIP ringer while the specified number reach. 1. Make sure the phone is OFF. 2. Press the CHANNEL/SELECT mutton or SELECT button on handset or corded base respectively until the screen shows icon. 3. Press the “A” or button to review the memory and choose a memory. 4.
You're out of range of the base. MESSAGE INDICATORS i The following indicators show the status of a message or of the unit UNAVAILABLE The person is calling from a number that has NO CALL been blocked from transmission. No Alter ID information was received. TROUBLESHOOTING TIPS CALLER ID Problem No Display Solution + Is battery fully charged? Try replacing the battery. Make sure the battery is properly installed and connected.
FCC Part 68 supplementary information An applicable certification jacks Universal Service Order Codes (SOC) for the equipment is provided REJOICE in the packaging with each piece of approved terminal equipment. A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTS. A compliant telephone cord and modular plug is provided with this product.