User's Manual

Please read this user’s guide before
installing, setting up and using your new product
www.radioshack.com
To power your slider, you will need one 9V battery
for the transmitter and six AA batteries for the
slider. None are supplied, but all are available at
your local RadioShack or online at
www.radioshack.com.
in the transmitter
• Dispose of old batteries promptly and properly. Do not burn or bury batteries.
• Use only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or
rechargeable batteries of different capacities.
• If you do not plan to use the toy for several days, remove the batteries. Batteries can leak chemicals that
can damage electronic parts.
• Batteries purchased for use in this toy may pose a hazard to children. Please check the safety notice
supplied with batteries before use.
Note: Actual product may vary from the images
found in this document. Photos not to scale.
Thank you for purchasing your Micro Slider from
RadioShack. This tiny vehicle will dazzle your
friends because of all the cool stunts it can do. The
slider is available in two frequencies (27 and 49
MHz) so that you can race other radio-controlled
vehicles.
Micro Slider transmitter
charger user’s guide
60-4394
micro slider
in the charger
1. Remove the charger’s battery compartment
cover. Replace
when fi nished.
NOTE
2. Place the 9 volt
battery in the
compartment
as indicated
by the polarity
symbols
(+ and -).
1. Remove the
cover. Replace
when fi nished.
When the transmitter’s range
decreases, replace its battery.
2. Install six AA
batteries into
charger’s battery
compartment as
indicated by the
polarity symbols
(+ and -).
Micro
Slider
Transmitter
Charger