User's Manual

ManualsBrandsCCL ManualsElectronicsTransmitter

LONG RANGE WIRELESS FLOATING POOL & SPA SENSOR

Model: C3107B

User Manual

Thank you for selecting this delicate pool & SPA sensor. Utmost care has gone into the

design and manufacture of the sensor. Please read the instructions carefully according to

the version you purchased and keep the manual well for future reference.

OVERVIEW

WIRELESS THERMO POOL SENSOR

1. LCD display

2. Thermo sensor

3. [ °C /°F ] key

4. [ CHANNEL ] slide switch

- Assign the sensor to channel 1,2,3,4,5,6 or 7.

5. Battery compartment

- Accommodates 2 x AA size batteries.

6. [ RESET ] key

7. Wire hole

8. Top case lock indicator

GETTING STARTED

1. Turn the bottom case anti-clockwise

to open.

2. Select the sensor channel.

3. Remove the battery door.

4. Insert 2 x AA size batteries into the

battery compartment. Make sure you

insert them the right way according to

the polarity information marked on the

battery compartment.

AA x 2

5. Close the battery door.

6. Twist the bottom case clockwise and

make sure the top and button lock

indicator align to complete the setup.

NOTE:

Ensure the water tight O-ring is properly

aligned in place to ensure water resistant.

NOTE:

- Do not twist the sensor cable and keep it straight.

- Once the channel is assigned to a Wireless thermo sensor, you can only change it by

removing the batteries or resetting the unit.

- After replacing the batteries of the wireless sensor or the unit fails to receive wireless

sensor signal of a specied channel, press [ SENSOR ] key on the console unit to

manually receive the sensor signal again.

LCD DISPLAY ON THE SENSOR

Once the sensor power up, you can nd the following information that show on the

sensor’s LCD display.

1. Current channel of the sensor (e.g. switch to channel “6”)

2. Low battery indicator

3. Current Temperature reading

WIRELESS SENSOR SIGNAL RECEIVING (DISPLAY CONSOLE)

This pool sensor can support different 7CH console, user can base on the following step

to setup the display console.

1. In normal mode, press the console [ SENSOR ] key once to start receiving the

sensor signal of current on displaying channel. The signal icon will ash.

For example, when CH 6 is displayed, pressing [ SENSOR ] key will start receive for

CH 6 only.

2. The signal icon will ash until the reception succeeded. If no signal is received within

5 minutes the icon will disappear.

Summary of content (2 pages)

PAGE 1
2. Select the sensor channel. LONG RANGE WIRELESS FLOATING POOL & SPA SENSOR Model: C3107B User Manual 3. Remove the battery door. Thank you for selecting this delicate pool & SPA sensor. Utmost care has gone into the design and manufacture of the sensor. Please read the instructions carefully according to the version you purchased and keep the manual well for future reference. OVERVIEW WIRELESS THERMO POOL SENSOR 3 1 2 6 4 5 4. Insert 2 x AA size batteries into the battery compartment.
PAGE 2
IMPORTANT NOTE The icon blinks once every time when incoming wireless sensor signal is received (every 60s) Fair wireless sensor signal Weak wireless sensor signal -- Read and keep these instructions. -- Do not subject the unit to excessive force, shock, dust, temperature or humidity. -- Do not cover the ventilation holes with any items such as newspapers, curtains etc. -- Do not clean the unit with abrasive or corrosive materials. -- Do not tamper with the unit’s internal components.