INSTRUCTION MANUAL Video Tripod with Fluid Head
Location of Components 2 ● 3 ● 1 4 ● ● 5 ● 6 ● 8 ● 7 ● 9 ● 10 ● 11 ● 1 Quick Release Plate Safety Button 2 3/8" Thread for Accessories 3 Tilt Locking Knob 3/8" Screw Mounting Base Quick Release Plate Pan Bar Locking Lever Detachable Pan Bar Pan Locking Lever Leg Locking Knob 4 5 6 7 8 9 10 Leg Brace 11 Rubber foot
Extending Tripod Legs Open the leg locks to adjust the tripod to the desired height. Mounting Film Heads on Video Tripod 1. If film head comes without mounting bowl: first screw the bowl on the heads flat base and tighten the tree locking screws on the bottom of the bowl, using an Allen Key. 2. Install the head with bowl into the bowl-base of the tripod and tighten the bowl handle from beneath.
Quick Release Plate The Quick Release Plate can be slid +/- 20mm to perfectly balance Equipment. Releasing and Installing a Quick Release Plate Due to an integrated safety button, Cayer film heads prevent unintentional sliding out of the QR plate with equipment. 1. Loosen the QR Plate Locking Lever, then press the QR Plate Safety Button to release QR plate. 2. Screw QR plate onto bottom of the camera, using the mounting screw. Then slide back the camera with QR plate onto film head.
Operating the QR Plate Locking Lever Move the lever half a turn forward or backward. Release the locking lever to engage the teeth. The lock can now be released or tightened. Tilt & Pan Adjustment Unlocking the Tilt Locking Knob allows tilting +/- 90 degrees. Unlocking the Pan Locking Lever allows 360 degrees panning.
Safety Instructions Thank you for choosing a CAYER product. Please read the safety instructions carefully before using the product. The load capacity specified in the specifications must not be exceeded. Ensure that all fasteners are tightened and safety catches engaged during work to prevent accidental damage or injury. Do not use the product in temperatures below -20°C or above +70°C. Contact with seawater is not recommended and may cause serious damage.
After use in wet, dirty or sandy environments, it is recommended to clean and dry the product with a soft cloth. Dirt, dust and sand in all closures and threads should be removed after use. Clean only with mild detergent or alcohol. To be on the safe side, do not use or store the product near electrical power sources and chemical substances. Zhongshan Cayer Photographic Equipments Co.,Ltd.