C a stle Ne t BTC 08R800 Use r G uide User Guide Blue to o th 3.0/ 2.1+EDR Emb e d d e d Mo d ule C a stle Ne t Te c hno lo g y Inc . C o p yrig ht © 2011 All Rig hts Re se rve d .
C a stle Ne t BTC 08R800 Use r G uide Fe de ra l Com m unic a t ion Com m ission I nt e rfe re nc e St a t e m e nt This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
C a stle Ne t BTC 08R800 Use r G uide This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
C a stle Ne t BTC 08R800 Use r G uide Ca na da -I ndust ry Ca na da (I C) Operation is subject to the following two conditions: this device may not cause interference and this device must accept any interference, including interference that may cause undesired operation of the device. IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment with IC radiation exposure limits set forth for an uncontrolled environment.
C a stle Ne t BTC 08R800 Use r G uide 1. INTRODUCTION The BTC08R800 series is a embedded Bluetooth module, smallest form factor for Notebook and handheld PC. The Bluetooth function is based on CSR BlueCore8 PC-ROM single chip, which is fully compliant with Bluetooth 2.1 specification plus EDR. It has good RF performance. Lowest power consumption, piconet and scatternet capability. The interface is HCI USB compliant with USB fully speed (12Mbits).
C a stle Ne t BTC 08R800 Use r G uide 3. Block Diagram 4. INSTALLATION 4.1 Installed in Laptop PC The Mainboard of the system should provide a Host connector and Cable connection for BT module. Please follow the SOP to install & assemble it step by step. 4.2 Testing in Lab The module is embedded inside Notebook. If for testing purpose, we provide the “USB Testing Board” in order to let tester connect BTC08R800 via the special cable connection to PC externally. The USB Testing Board provides +5V/3.
C a stle Ne t BTC 08R800 Use r G uide After Hardware installation, when system find the new hardware, please install the driver / software correctly. C a stle Ne t Te c hno lo g y Inc . C o p yrig ht © 2011 All Rig hts Re se rve d .