Castle Mamba Monster 2 Quick Start Guide
QUICK START GUIDE
IMPORTANT: You must calibrate your radio to the ESC!
1. Install the ESC
• Solder a high quality battery connector to the ESC. Mount the ESC
and motor into the vehicle
• Plug in the 3 motor wires to the ESC
• Plug in the ESC Rx lead to CH2 on your receiver
• Make sure the ESC’s switch is o
2. Calibrate the radio transmitter
• Plug in a battery
• Holding full throttle on your transmitter, turn the switch ON
• After a few seconds you’ll hear multiple tones and the red LED
will come on
• Now hold full brake and after a few seconds you’ll hear multiple
tones and the yellow LED will come on
• Now relax to neutral and after a few seconds you’ll hear multiple
tones and ALL the LEDs will light up.
• A few seconds later the ESC will arm with a double tone and
you’re ready to go!
Revised 11/2012 P/N: 095-0225-00
Waterproof: The Mamba Monster 2 ESC is resistant to water, but it is not intended for continuous
operation while submerged. If the ESC is operated in wet conditions, rinse with fresh water to remove
dirt or corrosives and then fully dry the ESC. The ESC fan is not water resistant. Remove the fan from
ESC before exposing the vehicle to liquids. Always check to see that the rest of the components in your
vehicle can withstand getting wet.
Deans®, Traxxas,® TRX,® and Power Cell® are trademarks of their respective owners.