User`s guide

35
Operation errors, Instrument status problems, Data Editor operating environment problems, and other factors can cause error
messages to appear during operation. Look up the error message in the list below and perform the required action as noted.
Error Messages
Message Cause Required Action
Already Running A different instance of Data
Editor is already running.
Use the already running instance of Data Editor.
Bulk Dump is Disabled The Instrument’s bulk dump
data transfer function has
been disabled for some
reason.
On the Instrument, display the stage setup selection screen. If
there is an ongoing recording operation or if there is a paused
recording operation, cancel it.
Communication Error An error occurred during
communication with the
Instrument.
• Check the connection between the computer and
Instrument.
• Make sure the Instrument MIDI settings and Data Editor
MIDI settings match.
• On the Instrument, display the stage setup selection screen.
If there is an ongoing recording operation or if there is a
paused recording operation, cancel it.
• If another application is running, exit it.
• Make sure there is only one computer connected to the
Instrument. Do not have multiple computers connected to
the Instrument.
• Do not perform any keyboard operations while data
communication is in progress.
• If you are connected via a USB hub or extension cable,
change to a direct connection.
• If the above actions do not resolve the problem, try turning
the Instrument off and then back on again. Also try
restarting Data Editor.
File Read Error An error occurred during a file
or folder read operation.
• Check to make sure the file or folder you are trying to read
actually exists.
• Check to make sure the file or folder you are trying to read
is readable.
• Check if the file is being used by another application.
• Check to make sure that the paths to the data file folder do
not contain any illegal characters.
• If either path contains illegal characters, change the data file
folder to a folder whose path is made up only of supported
single-byte alphanumeric characters.
File Write Error An error occurred during a file
or folder write operation.
• Check to make sure the location where you are trying to
create the file or folder actually exists.
• Check to make sure the file or folder you are trying to write
to actually exists.
• Check to make sure the file or folder you are trying to write
to is writable.
• If you are trying to write to a USB flash drive, check to make
sure that its protect switch is not in the write protect position.
• Check if the file is being used by another application.
• Check to make sure that available computer or USB flash
drive memory space is sufficient.
• Check to make sure that the paths to the data file folder do
not contain any illegal characters.
• If either path contains illegal characters, change the data file
folder to a folder whose path is made up only of supported
single-byte alphanumeric characters.