User`s guide

25
Basic Operation
The following is the basic flow for package file editing.
1. Create a new package file.
2. Register user data files to the package file.
3. Save the edited package file.
Click the “(4) Save package file button”. This will display a dialog box for assigning a name to the package file. Specify a
name and save the file.
• The file name extension for package files is “.ZPK”.
Use of a file with a file name extension other than “.ZPK” is not supported.
Using the Package Edit Tab
To create new package file immediately after starting up Data Editor, click the Package Edit tab. This will immediately
enable package file editing. To discard the package file you are currently editing and create a new one, click the “(2) New
package file button”.
• If the package file you are editing has not been saved yet, a confirmation dialog box will appear. For details, see “Save
Confirmation Dialog Box” on page 26.
1. Use the “(1) Data type selection box” to select the type of data you want to register to the
package file.
2. Use the “(9) Package content file view tabs” to select the Current Category tab.
3. In the “(8) Computer file list”, find the data file you want to register to the package file.
4. In the “(10) Package content file list”, find the area to which you want to register the file.
5. Drag the file from the “(8) Computer file list” and drop it into the “(10) Package content
file list” area.
6. Repeat the above steps as many times are required.