User Manual

ManualsBrandsCasio ManualsCash registersPCR-T276

1. Name of Parts

Printer cover

Drawer

Mode switch

Keyboard

OPEN button

Paper cutter

2. To install memory protection batteries

1 Open the printer cover by pushing OPEN

button.

OPEN

2 Remove the battery compartment cover and

install two new “AA” type alkaline batteries in

the battery compartment.

3 Replace the battery compartment cover. Please

make sure that the battery compartment cover

is fastened securely with a click sound.

Important

• Be sure that the plus (+) and minus (-) ends of

the batteries are facing in the directions as

indicated on the battery compartment.

• The Cash Register will show “l” on the

display when the batteries are running low

on power. Install two new batteries when this

occurs.

3. To set a paper roll

This Cash Register is tted with a thermal printer - only 58 mm wide thermal paper rolls can be used.

1 Open the printer cover by pushing OPEN

button.

OPEN

2 Hold the paper roll so that the end of the paper

comes out from the bottom of the roll and place

it behind the printer.

3 Place the end of the paper over the printer.

4 Close the printer cover slowly until it locks

securely. Be sure that both sides of the cover

are fastened securely.

Notes:

• Never touch the printer’s thermal head and the platen. Avoid the thermal paper from heat,

humidity or direct sunlight.

• When you open the printer cover, be careful not to touch the paper cutter to prevent your

nger from a cut.

Important

• If the thermal paper roll is not properly installed, you will not be able to use the Cash Register. The

display shows ‟ ” to indicate that the paper is not inserted.

4. Get the Cash Register ready

1 Insert a Mode key marked PGM that comes with the Cash

2 Plug in the power cord into an AC outlet.

5. To set the language, date, time, and pairing with a smartphone

To print date and time of transactions on receipts, set present date and time. Also using smartphone

application “CASIO ECR+”, you can set the Cash Register quickly and easily. To utilize the application,

the Cash Register must be paired with a smartphone.

Important

• In each setting of date and time, the Cash Register prints your settings. Make sure that the settings

are correct. If you have made incorrect date and time setting, use y key to correct it. Pressing y

key moves the blinking digit to the left. Move the blinking to the digit you wish to correct and input

the correct number. For other incorrect settings, pull out the AC cord, take out batteries, and start

from the beginning.

1 As soon as you plug in the power cord, the printer prints instructions for selecting the language. Input

the language number and press p key. For example, if you wish to select English, press ?

p keys.

2 The printer prints the instructions for setting date and time and the top digit of the display ashes.

Enter the date in order of month, day, and year. For example, input 092119 for September 21, 2019.

After then, display changes for setting time. Enter the present hours and minutes in 24 - hour system.

For example, 1300 for 1:00 pm.

3 The Cash Register prints to ask if you wish to pair with your smartphone. Press p if you utilize

the smartphone application “CASIO ECR+” then proceed to step 4. If not, press k to complete the

settings.

Note:

You can choose “NO” here and pair Cash Register and a smartphone later. See “To pair

Cash Register and a smartphone in program mode”.

4 Scan the QR code printed on top of this guide and install application “CASIO ECR+” on your smart-

phone.

5 Set your smartphone to enable Bluetooth connection. For Bluetooth setting of your smartphone, refer

to the operation manual of your smartphone.

6 Place your smartphone within one meter from the Cash Register. The

Cash Register prints 14-digit device code starting “EY”.

PGM

ENABLE THE BLUETOOTH

OF YOUR SMARTPHONE AND

PAIR WITH THE DEVICE

NAME LISTED BELOW.

EY123456789012

CANCEL<SUBTOTAL>

7 On your smartphone, nd paired Cash Register’s device code. Operations di󰀨er between Android

and iPhone.

On Android Bluetooth setting, nd and select printed device code of the Cash Register. In this exam-

ple, EY123456789012.

By starting application “CASIO ECR+”, your smartphone searches target Cash Register. Select the

Cash Register to be paired. In this example, EY123456789012. Note that the device code di󰀨ers

depending on each Cash Register. Make sure to select the printed device code.

8 After you select the device code on the smartphone, the Cash Register

displays a pass key. Input the pass key on the smartphone in this example

123456. Pass key di󰀨ers depending on each Cash Register.

9 When the pairing is completed successfully, the Cash Register prints “PAIRING SUCCESSFUL”.

Note:

If the pairing cannot be done successfully, unplug the power cord, remove the batteries and

put them in again then plug in the cord and retry from Step 1. You can also pair Cash Register

and a smartphone in program mode. See the following section.

To pair Cash Register and a smartphone in program mode

If you did not pair Cash Register and a smartphone in the above steps, you can pair them later by the

following procedure.

1 Set your smartphone to enable Bluetooth communication.

2 With a smartphone, scan the QR code printed on top of this guide and install the

application “CASIO ECR+”.

3 Turn the Mode switch to PGM position.

4 Input ZX???k.

5 Following printed instructions, input device code and pass key. See steps 5 to 9 of the above sec-

tion for details.

Note:

If you pair your smartphone and Cash Register, read/reset reports (X/Z) are done by “Remote

X/Z” of smartphone application “CASIO ECR+”.

123456

Mode Switch

6. Key functions

—

PLU

/POST

RCPT

SUB

TOTAL

TAX PGM

/PAPER

SAVING

/DEPT

SHIFT

/ERR.

CORR

FEED

/CLK #

AMT

TEND

X/FOR

/DATE

/TIME

RA/

T/S 1

PO/

T/S 2

CHK

/NS

TAXABLE

−

NON-TAX

The followings show the major functions of the keys.

l: Use this key to feed the paper roll.

x: Use this key to show present date and time.

Use this key to input quantity for a multipli-

cation. Also this key is used for registrations

of split sales of packaged items.

y: Use this key to clear an entry that has not

yet been registered.

g: Use this key to correct immediately preced-

ing registration. Also this key is used for

reducing price.

:: Use this key for discounts. Also this key is

used to sign a clerk on or o󰀨.

g: Price look up key. Use this key to register

preset items by number. When the Register

is set to not to print receipts, pressing

this key prints a receipt of the preceding

transaction.

;: Use this key to set tax statuses and tax

tables. Use this key to stop issuing receipts

to save paper.

? to >"': Ten-key. Use these keys for

numeral entries.

a to 8: Department keys. Use these keys to

department.

c: Use this key following a numeric entry

to register money received by non-sale

transactions. Also use this key without a

numeric entry to change taxable 1 status of

the following item.

v: Use this key following a numeric entry to

Also use this key without a numeric entry

to change taxable 2 status of the following

item.

j: Department shift key. Pressing this key

once prior to Depts. 1 to 8 keys registers

items in Depts. 9 to 16 whereas pressing

this key twice registers in Depts. 17 to 24.

Also this key prints preceding number entry

without any registration.

m: Use this key to register charge sales. Also

this key is used for opening drawer.

k: Use this key to display and print the current

subtotal amount.

m: Use this key for check payments.

p: Use this key to register cash sales.

Mode switch

PGM: Use this position for setups.

RF: Use this position for refunding.

OFF: Use this position to turn the Cash Register o󰀨.

REG: Use this position for registrations.

CAL: In the CAL mode, the Cash Register functions as a calculator.

X: Use this position to print the sales report. After the reporting, all the sales

data remain in the memory.

Z: Use this position to print the sales report. After the reporting, all the sales

data is cleared from the memory.

Mode keys

PGM

There are two types of mode keys. The program key marked “PGM” and the

operator key marked “OP”. The program key can set the Mode switch to any

position, while the operator key can select only OFF, REG, and CAL positions.

7. Specications

Main display Amount 8 digits (zero suppression); Department/PLU No.; No. of repeats; Total/

Change

Customer display Amount 8 digits (zero suppression)

Paper roll 58 (W) x 80 (D) mm

Memory protection battery The e󰀨ective service life of memory protection batteries (two new size AA

alkaline batteries) is approximately one year from installation into the machine.

Bluetooth Supported version Bluetooth® low energy

Option WT-97

Accessories Roll paper, Mode keys, Quick start guide, Drawer hook

Specications and design are subject to change without notice.

Quick Start Guide

PCR-T276

SM-T277

SR-S720

Electronic Cash Register

Note : This manual describes basic setups and operation methods. For more detail, please down-

load the User’s Manual from: https://world.casio.com/manual/sa/

Thank you very much for purchasing this CASIO electronic Cash Register.

START-UP is QUICK and EASY!

Power Supply

Your Cash Register is designed to operate on standard household current (120 V, 220 V, 230 V, 240 V;

50/60 Hz). Do not overload the outlet by plugging in too many appliances.

Cleaning

Clean the Cash Register exterior with a soft cloth which has been moistened with a solution of a mild

neutral detergent and water, and wrung out. Be sure that the cloth is thoroughly wrung out to avoid

damage to the printer. Never use paint thinner, benzene, or other volatile solvents.

The mains plug on this equipment must be used to disconnect mains power. Please ensure that the

socket outlet is installed near the equipment and shall be easily accessible.

Preparations

Please follow the steps described below.

• Unpack the Cash Register and DO NOT plug into the mains supply until sections 1, 2, and 3 have been

completed.

• To prevent losing all your settings and sales data, we strongly recommend that you install the memory

protection batteries before you use the Cash Register and replace them at least once a year.

MA1906-B QSG201*INC-E2

https://web.casio.com/ecr/app/

Electronic Cash Register can be

set by Smartphone Try it !

To use the Cash Register safely

Warning Power plug and AC outlet

• Use only a proper AC electric outlet. Use of an outlet with a di󰀨erent voltage from the rating

creates the danger of malfunction, re, and electric shock. Overloading an electric outlet

creates the danger of overheating and re.

• Make sure the power plug is inserted as far as it will go. Loose plugs create the danger of

electric shock, overheating, and re.

Do not use the register if the plug is damaged. Never connect to a power outlet that is loose.

• Use a dry cloth to periodically wipe o󰀨 any dust built up on the prongs of the plug. Humidity

can cause poor insulation and create the danger of electric shock and re if dust stays on

the prongs.

• Do not allow the power cord or plug to become damaged, and never try to modify them in

any way. Continued use of a damaged power cord can cause deterioration of the insulation,

exposure of internal wiring, and short circuit, which creates the danger of electric shock and

re.

Contact CASIO service representative whenever the power cord or plug requires repair or

maintenance.

WARNING: This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may

cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to

cause harmful interference in which case the user will be required to correct the interference at his own expense.

GUIDELINES LAID DOWN BY FCC RULES FOR USE OF THE UNIT IN THE U.S.A.

(Not applicable to other areas)

FCC WARNING

Changes or modications not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment. Proper connectors must be used for connection to host

computer and/or peripherals in order to meet FCC emission limits.

WARNING

THIS IS A CLASS A PRODUCT. IN A DOMESTIC ENVIRONMENT THIS PRODUCT MAY CAUSE RADIO INTER-

FERENCE IN WHICH CASE THE USER MAY BE REQUIRED TO TAKE ADEQUATE MEASURES.

The Bluetooth wordmark and logo are registered trademarks of Bluetooth SIG, Inc. and

are used by permission granted to Casio Computer as a certied logo user.

• Android is a trade mark and registered trade mark of Google LLC.

• iPhone is a trade mark registered in the USA and other countries.

Interference with the Operation of Other Equipment (Using Wireless Data Communication)

Keep your Cash Register well away from anyone wearing a pacemaker. Radio waves emit-

ted by the Cash Register can a󰀨ect the operation of a pacemaker.

EY201QSG_US-e.indd 1 2019/06/27 11:23:03

Summary of content (2 pages)

PAGE 1
. Name of Parts To use the Cash Register safely * + Quick Start Guide PCR-T276 SM-T277 SR-S720 https://web.casio.com/ecr/app/ + Electronic Cash Register can be set by Smartphone Try it ! + Electronic Cash Register - Note : This manual describes basic setups and operation methods. For more detail, please download the User’s Manual from: https://world.casio.com/manual/sa/ Your Cash Register is designed to operate on standard household current (120 V, 220 V, 230 V, 240 V; 50/60 Hz).
PAGE 2
8. Basic setups Using smartphone application “CASIO ECR +”, you can easily set up the basic setups. If you do not utilize the application, follow the undermentioned procedures. Those setups make you simple and quick registrations. Mode Switch To preset unit price to each department By presetting unit prices to the departments, you can register an item just by pressing a Dept. key. Step Operation 1 Mode switch to PGM 2 3 Turn the Mode switch to PGM position and press Zk keys.