User Manual
Table Of Contents
- Contents
- Establishing a Network Connection Between a Computer and the Projector
- Configuring Projector Network Settings
- Using a Computer to Configure Projector Network Settings
- Preparing for C-Connection
- Network Projecting a Computer Screen Image (Using C-Connection)
- C-Connection Details
- Advanced Operations
- Ports Used for TCP/UDP
42
5.
To exit the user list screen press the [ESC] key.
This will start projection from all terminals for which (projecting) was selected.
If the status of all terminals becomes (not projecting), the network standby screen will
appear.
Note
If the projector detects HDMI input during projection of the user list screen, it may
automatically start HDMI projection and then immediately return to network projection. If this
happens, perform the operations below.
– To return to the user list screen, press the [ESC] key.
– To switch to HDMI projection, either display the projector’s Frequent Functions Menu and
execute the Switch Input command, or disconnect and then reconnect the HDMI cable.
Projector Remote lets you perform projector operations remotely from a computer.
To perform projector operations from a computer
1.
Use the computer to display the projector’s Web Service page (page 12).
2.
Input the password into the “Projector Remote” box, and then click the [Login]
button.
The initial default password is: moderator.
3.
Use the buttons in the displayed window to control the projector.
4.
After you are finished, click the [Logout] button in the title bar of the window.
This will return to the top menu.
Note
The power button of the Projector Remote window cannot be used to turn on the projector.
Projector Frequent Functions Menu and Setup Menu operations cannot be performed from
the Projector Remote window.
Projector Remote