User Manual
Table Of Contents
- Contents
- Establishing a Network Connection Between a Computer and the Projector
- Configuring Projector Network Settings
- Using a Computer to Configure Projector Network Settings
- Preparing for C-Connection
- Network Projecting a Computer Screen Image (Using C-Connection)
- C-Connection Details
- Advanced Operations
- Ports Used for TCP/UDP
40
3.
If required, select the “Allow control from this page only.” check box.
While this check box is selected, projection start and projection layout settings can be
configured on this page only. The only operations that can be performed on a terminal
connected to the projector are stopping projection and terminating the connection.
While this check box is not selected, all operations can be performed on a terminal connected
to the projector.
4.
Perform Moderator operations as required.
Projection can be performed from as many as four terminals at the same time. While
projection is being performed from four terminals, you need to stop projection from one of
them before you can start projection from another terminal.
To see the projector’s login code, click the [Show Login Code] button. This causes the login
code (or “-” if the login code is disabled) to appear to the left of the button. Connection
information (page 16) will also be shown on the projection screen.
To do this: Perform this operation:
Start projection from a terminal
using auto layout
1. In the list of user names, find the name of the target terminal.
2. In the Projection Operation column, click .
Start projection from a terminal
using full screen
1. In the list of user names, find the name of the target terminal.
2. In the Projection Operation column, click .
Stop projection from a terminal 1. In the list of user names, find the name of the target terminal.
2. In the Projection Operation column, click .
Switch the projection layout of the
projecting terminal
1. In the list of user names, find the name of the target terminal.
2. In the Projection Operation column, click or .
Clicking switches to full-screen projection, while clicking
switches to auto layout projection.
Terminate the connection
between a terminal and the
projector
1. In the list of user names, find the name of the target terminal.
2. In the Projection Operation column, click .
Stop projection from all terminals Click .
Terminate the connections
between all terminals and the
projector
Click .