User Manual
Table Of Contents
- Contents
- Establishing a Network Connection Between a Computer and the Projector
- Configuring Projector Network Settings
- Using a Computer to Configure Projector Network Settings
- Preparing for C-Connection
- Network Projecting a Computer Screen Image (Using C-Connection)
- C-Connection Details
- Advanced Operations
- Ports Used for TCP/UDP
30
If you perform a network projection operation with two or more computers projecting on a single
projector, projection will be performed using one of the layouts below, depending on how many
computers are projecting (when the projection layout setting is “Auto Layout”.).
Note
The projector has two projection layout settings: “Auto Layout” and “Full Screen”. Even if
multiple computers are projecting, selecting the “Full Screen” projection layout setting on one
of the currently projecting computers will cause only the image of the computer to be
projected in a full-screen view. You can return to multiple computer image projection by
switching back to “Auto Layout”.
If four computers are already projecting to a single projector, projection operations from any
additional computers are disabled. Projection operations from another computer will be
enabled again if any one of the currently projecting computers is stopped.
Simultaneous Projection of Images from Multiple
Computers on a Single Projector
1 computer 2 computers 3 computers 4 computers