User Manual
Table Of Contents
- Contents
- Establishing a Network Connection Between a Computer and the Projector
- Configuring Projector Network Settings
- Using a Computer to Configure Projector Network Settings
- Preparing for C-Connection
- Network Projecting a Computer Screen Image (Using C-Connection)
- C-Connection Details
- Advanced Operations
- Ports Used for TCP/UDP
10
Configuring Projector Network Settings
Use the Setup Menu that appears on the projection screen to configure basic network settings.
Perform operations using projector controls or the optionally available remote controller.
Note
To configure more advanced network settings, use the projector’s Web Service page (page
12). However, note that the Web Service page does not have a setting that corresponds to the
“Wireless LAN Info” item shown in the table below.
Projector Setup Menu Network Setting Items
This menu item: Does this:
Wireless LAN Info Shows the current status of a wireless LAN connection.
Network Settings 3
IP Setting(LAN1)
Specifies how an IP address is specified when the projector is connected to a network.
Auto (initial default): Obtain an IP address automatically from a network DHCP server.
Manual: Manual IP address input.
Selecting the “Manual” option enables input for the following three items: “IP Address”,
“Subnet Mask”, and “Default Gateway”.
Note
This setting also affects the “LAN1 IP Settings” (page 21) below, which are on
the Web Service page.
Network Settings 3
Wireless LAN Function
Switches the projector’s wireless LAN function between “Enable” (initial default) and
“Disable”. This setting also affects the “Enable Wireless LAN” (page 17), which is on the
Web Service page.
Network Settings 3
Wireless LAN Mode
Select either of the settings below as the projector’s Wireless LAN Mode.
Access Point (initial default): In this mode, the projector operates as a wireless LAN
access point.
Client: In this mode, the projector operates as a wireless LAN client. Select this mode
when you want to connect the projector to an external wireless LAN access
point.
Network Settings 3
Update Network Settings
Applies changes to the projector that were made to the menu setting items included in
“Network Settings” 3 “Network Settings”.
Network Settings 3
Initialize Network
Settings
Returns network settings to their factory defaults.
Web Service Page Setting
Items
Projector’s Setup Menu Setting
Items
LAN1 IP Settings (Auto if not
checked)
Auto, Manual
IP Address, Subnet Mask,
Default Gateway
Menu setting items of the same
name.