Operation Guide 3210 Contents About this User’s Guide.......................................................................................... E-4 General Guide .......................................................................................................... E-5 Using Modes ............................................................................................................ E-6 Mode Overview ....................................................................................................
Operation Guide 3210 Bluetooth Connection 4. When pairing is complete, the watch displays a Bluetooth icon and switches to the Timekeeping Mode. x If the watch is unable to find a device to pair with or if the connection is interrupted, the watch display changes a shown below. After about one minute, the watch switches to the Timekeeping Mode. x The display shown below appears if the watch is unable to find a valid service.
Operation Guide 3210 Adjusting the Current Time Setting Having Bluetooth connection turned on while adjusting the time will automatically display the date and time synchronized with the connected device (mobile phone). Note The start of any communication operation will cause time sync to pause. It will resume after the communication operation is complete.
Operation Guide 3210 Entering the Alarm Mode Alarms and Hourly Time Signal You can set up to five different alarms. When any one of the alarm times is reached in the Timekeeping Mode, the watch will sound an alarm beeper or vibrate for about 10 seconds. The hourly time signal causes the watch to beep or vibrate every hour on the hour. 1. In the Timekeeping Mode, press C twice to enter the Alarm Mode.
Operation Guide 3210 4. After all the settings are the way you want, press A to exit the setting screen. Using the Setup Mode Performing a Countdown The following shows button operations for a timer countdown operation. You can use the Setup Mode to check device information and to configure various settings. D Checking Device Information and Enabled Service Information D Start D Stop D Restart B Stop In the Timekeeping Mode, press C five times to enter the Setup Mode.
Operation Guide 3210 Specifying the Illumination Duration Illumination 1. In the Timekeeping Mode, hold down A for about two seconds until the time zone area setting screen appears. 2. Press C 10 times to display the illumination duration setting screen. x The screen will show either [LT1] or [LT3]. 3. Press D to toggle the illumination duration setting between [LT1] (1.5 seconds) and [LT3] (3 seconds). 4. To return to the Timekeeping Mode, press A.
Operation Guide 3210 Operating Precautions Water Resistance x The following applies to watches with WATER RESIST or WATER RESISTANT marked on the back cover.
Operation Guide 3210 User Maintenance Caring for Your Watch x A dirty or rusty case or band can soil the sleeve of your clothing, cause skin irritation, and even interfere with watch performance. Be sure to keep the case and band clean at all times. Rust tends to form easily after the watch is exposed to seawater and then left without cleaning. x Sometimes a smudge like pattern may appear on the surface of a resin band. This will not have any affect on your skin or clothing.