Installation Guide

ManualsBrandsCascadia ManualsBathroom & Wall LightingBell 6-in W 1-Light New Bronze Transitional Wall Sconce

Short Screw (B)

Green Grounding

Screw (E)

Wire Nut (F)

141205

Page 1

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

W0176 / W0177

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Lock Nut

(D)

Long Screw (C)

Ball Nut (G)

Cross Bar(A)

1. Thread two long screws through the cross bar, then secure them with two lock nuts. Adjust the length of the long screws

if necessary.

Note: Make sure that the long screws are lined up horizontally, in order to ensure that the fixture will be level.

Attach the cross bar to the outlet box by using two short screws.

Assembly Instructions:

Turn off the power at fuse or circuit box.

Option 1:

This FIXTURE can be mounted in two ways.

Back Plate

Glass Bracket

Socket Ring

Bulb Type A Max.60W

(not included)

Socket

Glass Shade

Ball Nut (G)

Strain Relief (H)

Pipe Strap (N)

Dry Wall Screw (O)

Anchor (L)

Swivel (I)

Hex Nut (J)

Washer (K)

Threaded Pipe (M)

Green Grounding Screw (E)

Outlet Box

Wire Nut (F)

Long Screw (C)

Cross Bar (A)

Short Screw (B)

Lock Nut

(D)

House Grounding Wire

Fixture Grounding Wire

Fixture Wire

Summary of content (4 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS W0176 / W0177 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows: ---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source. ---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source. ---Attach the fixture grounding wire (usually bare wire) to the cross bar with the green grounding screw. Then connect it to the house grounding wire with a wire nut.
PAGE 3
2. Thread long screws through the cross bar, then secure them with two lock nuts. Adjust the length of the long screws if necessary. Note: Make sure that the long screws are lined up horizontally, in order to ensure that the fixture will be level. 3. Loosen and discard the green grounding screw from the cross bar. 4. Place the cross bar to a proper position. a) If the wall material is wood: Attach the cross bar to the wall, then secure the dry wall screws through the set holes to the wall.
PAGE 4
11. Attach the pipe strap to the connected pipe at the bottom, then secure it to the wall by using dry wall screws. a) If the wall material is wood: Attach the pipe strap to the wall, thread the dry wall screws through the holes on pipe strap, then secure them to the wall. b) If the wall material is cement: Mark the holes where you want to place the pipe strap on the wall.