Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0063
Back Plate
Ball Nut (G)
Bulb Type A Max.100W
(not included)
Rubber Pad (H)
Parts:
130606
Parts Number (4751MM)
Parts Number (7047PC)
Mounting Screw (B)
Green Grounding
Screw (C)
Lock Nut (F)
Wire Nut (E)
Photocell (I) (X1)
Cross Bar (A)
Ball Nut (G)
Metal Frame
Headless Screw (D)
Parts Number (9453CS)
Glass Panel (J) (X3)
Rubber Pad (H)
Photocell (I)
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
Loop
Nipple
Glass Panel (J)
Fig. 1
Clip
1. Thread two headless screws through the cross bar, then secure them with four lock nuts (two on
each side of the cross bar). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally, to ensure that the fixture will be
level.
2. Attach the cross bar to the outlet box by using two mounting screws.
Cross Bar (A)
House Grounding Wire
Green Grounding Screw (C)
Fixture Grounding Wire
Wire Nut (E)
Outlet Box
Fixture Wire
Mounting Screw (B)
Lock Nut (F)
Headless Screw (D)