Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2.
READ AND SAVE THESE INSTRUCTIONS .
CT-OWD060 / CT-OWD080
1. Attach the nipple to the mounting strap, then secure it with a washer and hex nut.
2. Attach the mounting strap to the outlet box by using two mounting screws.
3. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections using
the wire nuts:
---The black wire from the fixture to the black wire from the power source.
---The white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
4. Attach the back plate of the fixture to the mounting strap by inserting the nipple, then secure it with
the end cap.
CAUTION: With silicone caulking compound, caulk completely around where the back plate
meets with the wall surface to prevent water from seeping into the outlet box.
5. Turn on the power at the main fuse or circuit breaker box.
110303
Mounting Screw
Fixture Wire
Nipple
Mounting Strap
Hex Nut
Wire Nut
Washer
Fixture Grounding Wire
Back Plate
FEATURES:
Easy to install
Energy-saving LED lights
Green Grounding Screw
Outlet Box
House Grounding Wire
End Cap
9W Warm White LED
Module Included
Fixture