Parasailing: (5) FAN COMPANY Step 1. Remove the two 6-32 x 5/16" screws holding the bracket to the holster. Save screws for later, “BN STANDARD TOGGLE = SWITCH TUBER punting ®| ® ks prs 6 Lh MOUNTING I . HOLES Switch SWITCH cover CONTROL CONTROL PLATE BRACKET . BRACKET Standard Light Switch Rocker Light Switch Step A. Remove the two screws holding the switch cover plate. Step A. Break off the two tabs by pushing outward. Do nat remove the cover plate. Step B.
FAN COMPANY Open Battery Door by pressing down on the insert tab provided. install 4 "AAA" alkaline batteries in the space provided. Please observe paper polarity placement. Replace Battery Door. BATTERY DOOR STOLE Power turned off, interrupted or failure: The remote control is battery operated, therefore if the power is turned off, interrupted or you experience a power failure, the remote control remembers the previous setting for both fan and light. Button operation: \ Rapid button operation causes errati
ADVANSTOUCH"™ i. @ To Control the Plight 1. Make sure you have the UP icon next to the bulb icon. if not repeat the steps under “choosing the Light Control Sequence,” 2. Turn the light off, then press and hold the LIGHT button. After 2 seconds, the up light will come on at the lowest setting and gradually become brighter. 3. Release the LIGHT button when the desired brightness is reached. To Control Just the Down Light 1.
GT FAN COMPANY Pressing the SECURITY" program. The controller beeps and indicates SECURITY". The {it will automatically turn ON and OFF in a seemingly random manner over an gift and a quarter hour programmed cycle that is designed to give the home a "lived-in" look. Regardless of the light setting when switching to the Security mode (lights on or off, dim or bright), the lights will increase to high brightness and then begin the Security cycle.