LED Direction Indicator User Manual www.carrybright.
1. Package List ① LED direction indicator X 4 ② Remote controller X 1 ③ Small mounting bracket X 4 ④Rear seat mounting bracket X 1 ⑤ Silicon band X 6 ⑥ 1 split 4 charge USB cable X 1 ⑦ Friction pad sticker X 12 2. Notice Before Use - It’s recommended to use 5A/2A adapter to charge. - The charging or working hours may be slightly varied for different usage duration and interval. - Please make sure the bracket is firmly fixed and undamaged.
. Product Overview 4.Basic Operation 1. Stick the friction sticker to the corresponding area of the mounting bracket.
2. Lock the indicators on the bar bracket or seat tube bracket depends on your needs.
2a. Fasten the mounting bracket on the tube with the silicon ring. 3. Fasten the remote controller on the handlebar with the silicon ring. Please fully charge the LED Direction Indicator before use.
- Switch mode on remote controller: Click Mode Switch button to switch mode of the indicator Mode①: Small red light keeps flashing(for night caution); Mode②: Red light and yellow turn light keep flashing (Warning); Mode③: All lights turn OFF; * Turn signal can only be activated in MODE ① OR ③. * Please switch to MODE ③ after use for battery –saving by the Mode Switch button (Remote) or Power button (LED Direction Indicator).
Left Turn: Press left button ( ) to flash left turn signal for 30s; Left Turn: Press right button ( ) to flash right turn signal for 30s; Press corresponding turn button again to cancel the turn signal while signal is activated. * Turn signal can only be activated in MODE ① OR ③. 5.
Remote Control - Light source: LED - Waterproof Level: IP65 - Working hours: Standby 200 days - Battery: 180 mAh lithium battery - Working Distance: Within 10 meters from Turn Signal LED 6. Warranty Warranty - The LED Direction Indicator comes with 12 months warranty from the beginning of shipment. - If you have any question or concerns about the product, please drop us an email at carrybriht@carrybright.com. All contact will be answered within 24 hours.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Information The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.