User's Manual

ManualsBrandsCARRIN ELECTRONICS ManualsElectronicsTHERMO SENSOR

KW9075RFwithoutdoorcableprobe  WWVB

1.Features:

z RadiocontrolledclockwithWWVBsignal.

z 433MHzRFreceivingfrequency.

z PerpetualCalendarUptoYear2099.

z 12/24Hourtimedisplayselectable.

z Dailysnoozealarmfunction

z IndoorTemperaturemeasurement:range32F~122F

OutdoorTemperaturemeasurement:range58F~+158F



2.MainUnitAppearance:



PARTA: 

A1:RadioControlledTime.

A2:RadioControlledIcon

A3:AlarmIcon

A4:Second

A5:IndoorTemperature

A6:Date&DayofWeek

A7:OutdoorTemperature



PARTB:

B1:“SNOOZE”Button

B2:“+/12/24”Button

B3:“MODE/SET”Button

B4:“/C/F/

 “Button

B5:“RESET”Button

B6:“ALON/OFF”Button

B7:“ALERT”Button

B8:“SEARCH”Button

PARTC



433.92MHz RF receivin

fre

uenc

Summary of content (6 pages)

PAGE 1
KW9075RF with outdoor cable probe WWVB 1. Features: z Radio controlled clock with WWVB signal. z z 433MHz RF receiving frequency. 433.92MHz RF receiving frequency. Perpetual Calendar Up to Year 2099. 12/24Hour time display selectable. Daily snooze alarm function z Indoor Temperature measurement: range 32F ~ 122F z z Outdoor Temperature measurement: range 58F ~ +158F 2. Main Unit Appearance: PART A: A1: Radio Controlled Time.
PAGE 2
C1: Wall Mount Hole C3: Stand C2: Battery Compartment Cover 3. Outdoor Sensor Appearance. D1: Transmission Indication LED D5: “RESET” button D2: Outdoor Temperature D6: °C/°F” button D3: Battery Compartment D7: Stand D4: Wall Mount Hole D8: Cable probe 4. Getting Started: 4.
PAGE 3
5.2 Outdoor Thermo sensor The remote sensor should be securely mounted onto a horizontal surface. Note: Transmissions between receiver and transmitter can reach up to 100m in open area. Open Area: there are no interfering obstacles such as buildings, trees, vehicles, high voltage lines, etc. 6. RF Transmission The main unit automatically starts receiving transmission from outdoor thermo z sensor for outdoor temperature after batteries inserted. RF icon “ ” flashes on the LCD.
PAGE 4
z Stop scanning by holding “ ” button (B4) for 3 seconds. 7.2 Manual Time Setting: z In time display mode, hold “MODE” button (B3) for 3 seconds to enter z Clock/Calendar setting Mode. Press “+” (B2) or “ ” (B4) button to adjust the setting and press “MODE” button (B3) to confirm each setting.
PAGE 5
z Press “12/24” (B2) button to select 12 or 24 hours mode. 8. Thermometer 8.1 Temperature display z Press “°C/°F” (B4) button to select Temperature in Celsius mode/ Fahrenheit z mode. If the temperature is out of the measurable range, LL.L (beyond the minimum temperature) or HH.H (beyond the maximum temperature) will be shown on the LCD. 8.
PAGE 6
z Avoid placing the clock near interference sources/metal frames such as computer or TV sets. z Do not expose it to direct sunlight, heavy heat, cold, high humidity or wet areas z The outdoor sensor must not be set up and installed under water. Set it up in away direct sunlight and Rain z Never clean the device using abrasive or corrosive materials or products.