116 INSTRUCTOR’S DESK ASSEMBLY INSTRUCTIONS
TABLE OF CONTENTS REVISONS TABLE ASSEMBLY COMPONENTS PAGE 1 2 ………………………………………………………………………………………………………………………………………………………………………………………………………………….……………………………………………………………………………………..………………………………… ………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………………...
ASSEMBLY COMPONENTS Items Included In Hardware Box Part # 1-ASSEMBLY INSTRUCTIONS Part # 1-HARDWARE BOX 24 FT RUBBER BASE 100283 2-UPRIGHT RODS 3/4 DIA. X 36 L. 100004 1-ELECTRICAL BOX, 2X2.5 100033 1-CROSSBAR ROD, 3/4 DIA. X 48 L. 100006 1-GFI ELECTRIC OUTLET 100034 1-FIXTURE, L2900-132AWSA 90 DEG.
Assembly Instructions for 1116K and 1216K Instructor’s Desk Items not included but needed for assembly: 1. Screwdrivers and Wrenches 2. Liquid Nail or silicone adhesive (can be found in hardware stores) 3. Contact Cement 4. Tape measure Instructions: 1. Place the cupboard cabinet centered over the plumbing and gas. 2. Place the second cabinet in line with the cupboard cabinet leaving a 22” space between the cabinets for the back panel. 3.
4. Attach front apron between cabinets using the cleats and the 100649 #8 x ¾” screws provided. For aesthetic purposes you may want to set the apron in 1”. 5. Outline the top of the base unit with the Liquid Nail or silicone adhesive and place top on the unit. Let cure. Be sure to center the top on the base unit before the glue dries.
. Clean the top with water only. Be sure the area the sink is dropped in is clean and dry. 7. Put a bead of silicone seal along the cutout for the sink on the top. Lower sink in place. 8. Mount fixtures into place. 9. (If Applicable) Assemble the Rod Socket Assembly as shown in Figure 9A. (If Applicable) Attach Rod Sockets to Top as shown in Figure 9B.
Figure 9B 10. Attach the rubber base molding using contact cement. After the molding is in place; screw stainless steel corner brackets on each corner using the (100064) #6 x ½” screws provided, over the base molding.
11. Reverse pulls to the exterior of unit as shown. 12. All water, electrical and gas connections should be performed by a trained professional. 8 P:\B Hawley\Web Downloads\Tech Manuals\705127,705128-1116K TECH MANUAL.