RV LEVEL WIZARD FRONT 1} Set the Level Wizard Base Module into Extended Position (FIG. 10). 2) Turn ON both the Base Module and the Remote Module using the on/off buttons (FIG. 11 and FIG. 12). 3) Place the Base Module on the floor in the middle of the RV (FIG. 5) with the legs pointing Front to Rear and Left to Right, having the Front leg facing towards the front of the RV (FIG. 13), and watch the LED indicator lights. FIG.
RV LEVEL WIZARD The Level Wizard comes already calibrated. However, if it seems to be acting irrationally making it difficult to level the RV, the Level Wizard can be re-calibrated by following the instructions below: 1. Set the Base Module in Extended Position and place if Fig. i4 on a flat surface (FIG. 14). . 2. Be sure the Base Module is turned off. 3. Push and hold Base Module power button for 6 seconds, until all lights go RED then release bunion.
RV LEVEL WIZARD # After the leveling process is complete please be sure to put the Level Wizard Base Module into the Standard Position and to correctly store it together with the Remote Module, back in their own Handle Box. # Do NOT dispose of the Level Wizard's Handle Box. We recommend storing the Level Wizard in its own original Handle Box while not in use. eo The Level Wizard automatically shuts off after 10 minutes of staying idle. « The Remote Module range feet.
WARNING: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation FCC Additional Statement This device complies with Part 15 of the FCO Rules.